Cisco ASA 5506W-X 소프트웨어 설명서 - 페이지 24

{카테고리_이름} Cisco ASA 5506W-X에 대한 소프트웨어 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASA 5506W-X 37 페이지. Threat defense reimage guide
Cisco ASA 5506W-X에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (10 페이지), 구성 매뉴얼 (13 페이지), 빠른 시작 매뉴얼 (14 페이지), 간편한 설정 매뉴얼 (11 페이지), 마운트 및 연결 (12 페이지), 설치 매뉴얼 (46 페이지), 섀시 마운트 (10 페이지)

페이지 인쇄

Reimage the Firepower Threat Defense Device

Procedure

Step 1

Download the FTD boot image (see

FTD on the Management interface.

For the ASA 5506-X, 5508-X, 5516-X, ISA 3000: You must use the Management 1/1 port to download the

image. For the other models, you can use any interface.

Step 2

Download the FTD system software install package (see

FTP server accessible by the FTD on the Management interface.

Step 3

At the console port, reboot the Firepower Threat Defense device.

reboot

Example:

Enter yes to reboot.

Example:

> reboot

This command will reboot the system.

Please enter 'YES' or 'NO': yes

Step 4

Press Esc during the bootup when prompted to reach the ROMMON prompt.

Pay close attention to the monitor.

Example:

[...]

Booting from ROMMON

Cisco Systems ROMMON Version (2.1(9)8) #1: Wed Oct 26 17:14:40 PDT 2011

Platform ASA 5555-X with SW, 8 GE Data, 1 GE Mgmt

Use BREAK or ESC to interrupt boot.

Use SPACE to begin boot immediately.

Boot in

Press Esc at this point.

If you see the following message, then you waited too long, and must reload the FTD again after it finishes

booting:

Launching BootLoader...

Boot configuration file contains 2 entries.

[...]

Step 5

Erase all disk(s) on the FTD. The internal flash is called disk0. If you have an external USB drive, it is disk1.

Example:

rommon #0> erase disk0:

Cisco ASA and Firepower Threat Defense Reimage Guide

Download Software, on page

7 seconds.

Cisco ASA and Firepower Threat Defense Reimage Guide

2) to a TFTP server accessible by the

Download Software, on page

Continue?

2) to an HTTP or