Cisco ASA 5506W-X 마운트 및 연결 - 페이지 3

{카테고리_이름} Cisco ASA 5506W-X에 대한 마운트 및 연결을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASA 5506W-X 12 페이지. Threat defense reimage guide
Cisco ASA 5506W-X에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (10 페이지), 구성 매뉴얼 (13 페이지), 빠른 시작 매뉴얼 (14 페이지), 간편한 설정 매뉴얼 (11 페이지), 소프트웨어 설명서 (37 페이지), 설치 매뉴얼 (46 페이지), 섀시 마운트 (10 페이지)

Mount and Connect

You can only mount the chassis with the front panel oriented toward either the ceiling or the floor. Wall mounting in

other orientation is not supported.

What to do next

You can now install the cables and power cord, as described in

Connectivity, on page

Rack Mount the ASA

Follow these steps to mount the ASA to a rack-mount shelf.

Note

You mount only one ASA 5506H-X in the rack-mount shelf.

The dimensions of the ASA 5506H-X are 3.46 in. x 18.3 in. x 19.5 in. (8.79 cm x 46.48 cm x 49.52 cm). The

PID is asa5506h-rack-mnt=.

Step 1

Place the ASA upside down on a large, stable work area. If you are installing two ASAs in the shelf, place the second

ASA beside the first, also upside down.

Step 2

Invert the sliding trays and position the ASA(s) on top of them such that the front of the device(s) and the front of the

tray are in the same direction.

Step 3

Adjust the position of the first ASA and the tray until the three mounting holes in the dimples in the bottom of the shelf

are aligned with the mounting holes in the bottom of the ASA.

Step 4

Tighten the captive tray screws into the shelf to lock it into place.

Figure 2: ASA 5506-X and ASA 5506W-X in the Rack-Mount Shelf

Rack Mount the ASA

Connect Cables, Turn on Power, and Verify

Mount and Connect