Cisco ASA 5506W-X 섀시 마운트 - 페이지 4

{카테고리_이름} Cisco ASA 5506W-X에 대한 섀시 마운트을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASA 5506W-X 10 페이지. Threat defense reimage guide
Cisco ASA 5506W-X에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (10 페이지), 구성 매뉴얼 (13 페이지), 빠른 시작 매뉴얼 (14 페이지), 간편한 설정 매뉴얼 (11 페이지), 소프트웨어 설명서 (37 페이지), 마운트 및 연결 (12 페이지), 설치 매뉴얼 (46 페이지)

Rack-Mount the Chassis

Figure 2: Attach Cable Guides to Sliding-Rack Tray Flange

Two cable guides (part number 700-122664-01)

Right cable guide rack tray cutouts

a) Align the cable guides with the cutouts on the sliding-rack tray flange (see figure above).

b) At the rear of the sliding-rack tray, attach the left and right cable guides using the six Phillips M3 x 0.5 x 10 mm

screws (part number 48-0796-01).

Note

c) Set the sliding-rack tray aside. Continue with Step 2 to install the rack shelf on the chassis.

The figure in Step 8 shows the sliding rack tray with the cable guides attached.

Step 2

Place the chassis with the top facing down on a large, stable work area.

Step 3

Invert the rack shelf and position it on the chassis. You can mount the chassis with the front or rear panel facing front.

Mount the Chassis

Drive the screws in while facing the back of the sliding-rack tray.

Left cable guide rack tray cutouts

Six Phillips M3 x 0.5 x 10 mm screws (part number

48-0796-01)

Mount the Chassis