ACU-RITE 745604-NN 소프트웨어 업데이트 - 페이지 4

{카테고리_이름} ACU-RITE 745604-NN에 대한 소프트웨어 업데이트을 온라인으로 검색하거나 PDF를 다운로드하세요. ACU-RITE 745604-NN 6 페이지.
ACU-RITE 745604-NN에 대해서도 마찬가지입니다: 소프트웨어 업데이트 (6 페이지), 소프트웨어 업데이트 (5 페이지), 소프트웨어 업데이트 (6 페이지), 소프트웨어 업데이트 (6 페이지), 소프트웨어 업데이트 (5 페이지), 소프트웨어 업데이트 (6 페이지), 소프트웨어 업데이트 (7 페이지), 소프트웨어 업데이트 (3 페이지), 소프트웨어 업데이트 (5 페이지), 소프트웨어 업데이트 (3 페이지), 소프트웨어 업데이트 (3 페이지)

Console ID # 745604-NN



Recovery drive 1114023-01 only supports 745604-NN and all software versions

supported by those consoles. Attempting to make a backup on 1113777-NN will fail.



Recovery drive kit 1127022-01 with USB ID# 680480-03 supports 745604-NN and all

software versions supported by those consoles, as well as 1113777-NN consoles with all

software versions prior to R5. Attempting to make a backup on 1113777-NN with R5 or

higher will fail.



The new drive kit 1127022-01 with USB ID# 680480-04 supports all MILLPWR

consoles and all software versions to date or planned for the near future.

These enhancements/changes were made:

Users now have the ability to mark a step to be "skipped" when running program.

The Job Clock was improved to show the number of days when the number of hours exceeds

24.

Added Fine Rough parameter to Rough Mill cycle. Options are Retract (default) and Contour.

The contour option is only possible if the radius of the fine roughing tool is more than the half of

the radius of the coarse tool; otherwise, Retract is used regardless of setting.

Improved the startup/shutdown views and messages

The following functionality has been restored to run options:

1. "Graphics Only" button added to Run Options menu.

2. Pause and display OIM messages.

3. Support limited VIEW dialog functionality.

Added separate side & bottom finish amounts in the Contour step.

Added the ability to define basic islands using the contour of standard cycles. The supported

cycles are: rectangle, circle, slot, radial slot, and ring. These cycles now have a new parameter

that specify if the step is a pocket or just a contour. Locate the step immediately before the

associated custom pocket cycle choose contour if it is to be used as an island.

Console ID # 1113777-NN