Sony MHC-GRX30J 사용 설명서 - 페이지 8

{카테고리_이름} Sony MHC-GRX30J에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony MHC-GRX30J 49 페이지. Sony operating instructions mini hi-fi component system mhc-rxd5, mhc-r550, mhc-grx30, mhc-grx30j
Sony MHC-GRX30J에 대해서도 마찬가지입니다: 사용 설명서 (48 페이지)

페이지 인쇄
Sony MHC-GRX30J 사용 설명서
St ep 3: Preset t ing radio st at ions
(cont inued)
1
Press TUNER/BAND repeatedly
until the band you want appears in
the display.
The bands you can receive vary
depending on the model you purchased.
Be sure to check which bands you can
receive.
Every time you press this button, the
band changes as follows:
2 band model:
FM ˜ AM
3 band model:
FM n MW n SW
2
Press and hold + or – until the
frequency indication starts to
change, then release.
Scanning stops when the system tunes in
a station. "TUNED" and "STEREO" (for
a stereo program) appear.
ALL DISCS
3
Press TUNER MEMORY.
A preset number appears in the display.
The stations are stored from preset
number 1.
ALL DISCS
4
Press ENTER/NEXT.
The station is stored.
5
Repeat steps 1 to 4 to store other
stations.
8
Downloaded from:
Preset number
https://www.usersmanualguide.com/
To t une in a st at ion w it h a w eak
signal
Press + or – repeatedly to tune in the station
manually.
To set anot her st at ion t o t he
exist ing preset num ber
Start over from step 1. After step 3, turn the
jog dial to select the preset number you want
to store the other station.
You can add a new preset number after the
last preset number.
To erase t he preset st at ion
1 Hold down TUNER MEMORY until a
preset number appears in the display.
ALL DISCS
2 Turn the jog dial to select the preset
number you want to erase.
Select "ALL ERASE" when you want to
erase all the preset stations.
3 Press ENTER/NEXT.
MONO
TUNED
"COMPLETE" appears.
STEREO
When you erase a preset number, the preset
VOLUME
number decreases by one and all preset
kHz
MHz
ß
numbers following the erased one are
renumbered.
To change t he AM t uning int erval
(Except f or t he European and M iddle
East ern m odels)
The AM tuning interval is factory set to 9 kHz (10
kHz in some areas). To change the AM tuning
interval, tune in any AM station first, then turn off
VOLUME
the power. While holding down the ENTER/NEXT
ß
button, turn the power back on. When you change
the interval, AM preset stations will be erased. To
reset the interval, repeat the same procedure.
Tip
The preset stations are retained for half a day even if
you unplug the power cord or if a power failure
occurs.
VOLUME
ß