Sony MHC-RG11 사용 설명서 - 페이지 23

{카테고리_이름} Sony MHC-RG11에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony MHC-RG11 28 페이지. Sony operating instructions home stereo system mhc-rg4sr,mhc-rg30t,mhc-rg20,dx10
Sony MHC-RG11에 대해서도 마찬가지입니다: 사용 설명서 (28 페이지)

페이지 인쇄
Sony MHC-RG11 사용 설명서
Speakers
Sound comes from one channel or unbalanced
left and right volume.
• Check the speaker connection and speaker
placement.
Sound lacks bass.
• Check that the speaker's + and – jacks are
connected correctly.
CD Player
The CD tray does not close.
• The CD is not placed properly.
The CD will not play.
• The CD is not lying flat in the disc tray.
• The CD is dirty.
• The CD is loaded label side down.
• There is moisture on the CD.
Play does not start from the first track.
• The player is in program or shuffle mode. Press
PLAY MODE repeatedly until "PGM" or
"SHUF" disappears.
Tape Deck
The tape does not record.
• No tape in the cassette holder.
• The tab has been removed from the cassette (see
"To save a tape permanently" on page 21).
• The tape has reeled to the end.
The tape does not record nor play or there is a
decrease in sound level.
• The heads are dirty (see "Cleaning the tape
heads" on page 21).
• The record/playback heads are magnetized (see
"Demagnetizing the tape heads" on page 21).
The tape does not erase completely.
• The record/playback heads are magnetized (see
"Demagnetizing the tape heads" on page 21).
There is excessive wow or flutter, or the sound
drops out.
• The capstans or pinch rollers are dirty (see
"Cleaning the tape heads" on page 21).
Noise increases or the high frequencies are
erased.
• The record/playback heads are magnetized (see
"Demagnetizing the tape heads" on page 21).
Tuner
There is severe hum or noise ("TUNED" or
"STEREO" flashes in the display).
• Adjust the antenna.
• The signal strength is too weak. Connect the
external antenna.
A stereo FM program cannot be received in
stereo.
• Press STEREO/MONO repeatedly until
"MONO" disappears.
If other troubles not described above
occur, reset the system as follows:
1
Unplug the power cord.
2
Plug the power cord back in.
3
Press x, DISPLAY, and ?/1 at the same
time.
4
Press ?/1 to turn on the system.
The system is reset to the factory settings. All
the settings you made are cleared.
23