Sony MHC-RG40 - Mini Hi-fi Component System 사용 설명서 - 페이지 12

{카테고리_이름} Sony MHC-RG40 - Mini Hi-fi Component System에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony MHC-RG40 - Mini Hi-fi Component System 32 페이지. Sony mhc-dx30 stereo system: system manual
Sony MHC-RG40 - Mini Hi-fi Component System에 대해서도 마찬가지입니다: 사용 설명서 (32 페이지), 서비스 매뉴얼 (2 페이지)

Sony MHC-RG40 - Mini Hi-fi Component System 사용 설명서
Presetting radio stations (continued)
To erase a preset station
1
Press and hold TUNER MEMORY until a
preset number appears in the display.
2
Press . or > repeatedly to select the
preset number you want to erase.
Select "ALL ERASE" when you want to
erase all the preset stations.
3
Press ENTER.
"COMPLETE" appears.
When you erase a preset number, the preset
number decreases by one and all preset
numbers following the erased one are
renumbered.
To change the AM tuning interval
(except for the European and Middle
Eastern models)
The AM tuning interval is factory-set to 9 kHz
(10 kHz in some areas). To change the AM
tuning interval, tune in any AM station first,
then turn off the system. While holding down
ENTER, turn the system back on. When you
change the interval, all the AM preset stations
are erased. To reset the interval, repeat the
same procedure.
Tip
The preset stations are retained for half a day even if
you unplug the power cord or if a power failure
occurs.
12

Listening to the radio

— Preset Tuning

Preset radio stations in the tuner's memory first
(see "Presetting radio stations" on page 11).
1
Press TUNER/BAND repeatedly to
select "FM" or "AM".
2
Press . or > (or press PRESET +/
– on the remote) repeatedly to tune in
the desired preset station.
Preset number
* When only one station is preset, "ONE
PRESET" appears in the display.
To listen to non-preset radio stations
Use manual or automatic tuning in step 2.
For manual tuning, press m or M (or
TUNING +/– on the remote) repeatedly. For
automatic tuning, press and hold m or M
(or TUNING +/– on the remote).
Tips
• When an FM stereo program has static noise, press
STEREO/MONO repeatedly until "MONO"
appears. There will be no stereo effect, but the
reception will improve.
• To improve broadcast reception, adjust the supplied
antennas.
Frequency*