Sony MHC-RV2 사용 설명서 - 페이지 36
{카테고리_이름} Sony MHC-RV2에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony MHC-RV2 40 페이지. Sony operating instructions mini hi-fi component system mhc-rv2
페이지 인쇄Problems and remedies (continued)
Tape Deck
The tape does not record.
• No tape in the cassette holder.
• The tab has been removed from the cassette (see
"To save a tape permanently" on page 37).
• The tape has reeled to the end.
The tape does not record nor play or there is a
decrease in sound level.
• The heads are dirty (see "Cleaning the tape
heads" on page 38).
• The record/playback heads are magnetized (see
"Demagnetizing the tape heads" on page 38).
The tape does not erase completely.
• The record/playback heads are magnetized (see
"Demagnetizing the tape heads" on page 38).
There is excessive wow or flutter, or the sound
drops out.
• The capstans or pinch rollers are dirty (see
"Cleaning the tape heads" on page 38).
Noise increases or the high frequencies are
erased.
• The record/playback heads are magnetized (see
"Demagnetizing the tape heads" on page 38).
Tuner
There is severe hum or noise ("TUNED" or
"STEREO" flashes in the display).
• Adjust the antenna.
• The signal strength is too weak. Connect the
external antenna.
A stereo FM program cannot be received in
stereo.
• Press FM MODE on the remote repeatedly until
"MONO" disappears.
GB
36
If other troubles not described above
occur, reset the system as follows:
1
Unplug the power cord.
2
Plug the power cord back in.
3
Press x, GROOVE, and ?/1 at the same
time.
4
Press ?/1 to turn on the system.
The system is reset to the factory settings. All
the settings you made are cleared.
Messages
One of the following messages may appear or
flash in the display during operation.
CANNOT USE
• You pressed an invalid button.
NO DISC
• There is no CD on the disc tray.
OVER
• You have reached the end of the CD.
• You have reached the end of an MP3 file while
fast-forwarding.
"PROTECT" and "PUSH POWER" appear
alternately.
• A strong signal was input. Press ?/1 to turn off
the system, leave the system turned off for a
while, then press ?/1 again to turn on the
system. If "PROTECT" and "PUSH POWER"
appear alternately even after the system is turned
on again, press ?/1 to turn off the system and
check the speaker cord.
PUSH STOP
• You pressed PLAY MODE during play.
STEP FULL
• You tried to program 26 or more tracks (steps).
TOC READING
• The system is reading the TOC information of
the disc. Some buttons are not available.
WAIT
• The function is switching to the tuner.