Sony MHC-VX777 사용 설명서 - 페이지 21

{카테고리_이름} Sony MHC-VX777에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony MHC-VX777 36 페이지.

페이지 인쇄

Recording a CD by specifying

track order

— Program Edit

You can record tracks from all the CDs in the

order you want. When programming, make

sure the playing times for each side do not

exceed the length of one side of the tape.

Load a CD and a recordable tape into

deck B, then press CD.

Press PLAY MODE repeatedly until

"PROGRAM" appears in the display.

Press one of the DISC 1–3 to select a

CD.

To program all the tracks on a CD at once,

proceed to step 6 while "AL" appears in the

display.

Press . or > repeatedly until the

tracks you want appears in the display.

Press ENTER.

The track(s) is (are) programmed. The

program step number appears, followed by

the total playing time.

To program additional tracks, repeat

steps 3 to 5.

Skip step 3 to select tracks from the same

disc.

Press CD SYNC HI-DUB.

Deck B stands for recording. To reduce hiss

noise in low-level high frequency signals,

press DOLBY NR so that "DOLBY NR"

appears in the display. The REC PAUSE/

START button flashes.

Press DIRECTION to select g to

record on one side or j (or RELAY)

to record on both sides.

Press REC PAUSE/START.

Recording starts.

06TAP_MHC-VX777/VX555.p65 GB

Cancel Program

Edit

Clear a track from

the end

Tip

To check the required tape length for recording a CD,

press EDIT until "EDIT" flashes after you have

loaded a CD and pressed CD. The required tape

length for the currently selected CD appears, followed

by the total playing time for side A and side B

respectively (Tape Select Edit).

Note

You cannot use Tape Select Edit for discs containing

over 20 tracks.

Timer-recording radio

programs

To timer-record, you must preset the radio

station (see "Presetting radio stations" on page

17) and set the clock (see "Setting the time" on

page 8) beforehand.

Tune in the preset radio station (see

"Listening to the radio" on page 18).

Press CLOCK/TIMER SET on the

remote.

"DAILY 1 SET" appears.

Press cursor V/v repeatedly to select

"REC SET", then press ENTER.

"ON" appears and the hour indication

flashes in the display.

Set the time to start recording.

Press cursor V/v repeatedly to set the hour,

then press ENTER.

The minute indication starts flashing.

Press cursor V/v repeatedly to set the

minute, then press ENTER.

The hour indication flashes again.

MHC-VX777/VX555/VX555J 4-232-651-12 (1)

Press

PLAY MODE repeatedly until

"PROGRAM" or "SHUFFLE"

disappears from the display.

CLEAR on the remote in stop

mode.

continued

13/03/2001, 4:58 PM