Cisco ASA 5516-X 하드웨어 설치 매뉴얼 - 페이지 27

{카테고리_이름} Cisco ASA 5516-X에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASA 5516-X 32 페이지. Threat defense reimage guide
Cisco ASA 5516-X에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (8 페이지), 간편한 설정 매뉴얼 (11 페이지), 빠른 시작 매뉴얼 (9 페이지), 소프트웨어 설명서 (37 페이지), 마운트 및 연결 (6 페이지), 매뉴얼 (14 페이지)

Mount and Connect

You can configure any of the Gigabit Ethernet interfaces to be a management-only interface using the

management-only command. However, you cannot disable management-only mode on the Management 1/1 interface.

The following figure shows how to connect the network cables.

Figure 19: ASA 5508-X and ASA 5516-X Cabling

Gigabit Ethernet data interface (RJ-45)

Management 1/1 interface (RJ-45)

b) (Optional) Console port – For use with the CLI. Connect a computer or terminal server using a serial console cable

to either the RJ-45 or Mini USB Type B port.

Only one console port can be active at a time. When a cable is plugged into the USB console port, the RJ-45 port

becomes inactive. Conversely, when the USB cable is removed from the Mini USB Type B port, the RJ-45 port

becomes active. See

console port.

c) Gigabit Ethernet ports – For the network interfaces; use standard RJ-45 Ethernet cables.

You can use any available Gigabit Ethernet port on the ASA 5508-X or ASA 5516-X as a failover link. The failover

link interface is not configured as a normal networking interface; it should only be used for the failover link. You

can connect the failover link by using a dedicated switch with no hosts or routers on the link.

Online Only

Connect to a Console Terminal or PC, on page 24

Connect Cables, Turn on Power, and Verify Connectivity

Console port (RJ-45 or Mini USB Type B)

for specific instructions for connecting the

Cisco ASA 5508-X and ASA 5516-X Hardware Installation Guide