Sony MZ-R500 사용 설명서 - 페이지 25

{카테고리_이름} Sony MZ-R500에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony MZ-R500 40 페이지. Marketing specifications
Sony MZ-R500에 대해서도 마찬가지입니다: 사용 설명서 (20 페이지), 사용 설명서 (40 페이지), 제한 보증 (1 페이지), 사양 (2 페이지)

페이지 인쇄

Editing recorded tracks

You can edit your recordings by adding/

erasing track marks or labeling tracks and

MDs. Premastered MDs cannot be edited.

Notes on editing

• Do not move or jog the recorder while "Edit"

is flashing in the display.

• You cannot edit tracks on an MD that is

record-protected. Before editing tracks, close

the tab on the side of the MD (page 31).

• If you perform an editing operation while

playing, be sure not to turn the power off until

"Edit" disappears in the display.

• The lid does not open until "Edit" disappears

in the display after editing.

Erasing tracks

To erase a track

Note that once a recording has been

erased, you cannot retrieve it. Make sure

of the track you are erasing.

>MENU.

While playing the track you want to

erase, press ENTER, press

>MENU. repeatedly until

"EDIT" flashes in the display, and

then press ENTER again.

" and "Name" flash in the

display, and the recorder plays the

selected track repeatedly.

ENTER

Press >MENU. repeatedly

until "

" and "Erase" flash in the

display, and then press ENTER.

"Erase?" and "ENTER" appear

alternately in the display.

To cancel erasing, press x.

Press ENTER.

The track is erased and the next track

starts to play. All the tracks after the

one erased are automatically

renumbered.

To erase a part of a track

Add track marks at the beginning and the

end of the part you want to erase, then

erase the part (page 26).

To erase the whole disc

You can quickly erase all the tracks and

data of the MD at the same time.

Note that once a recording has been

erased, you cannot retrieve it. Be sure to

check the contents of the disc you want to

erase.

>MENU.

While the recorder is stopped, press

ENTER, press >MENU.

repeatedly until "EDIT" flashes in the

display, and then press ENTER again.

" and "Name" flash in the

display.

ENTER

continued

-GB