Sony MZ-R500 사용 설명서 - 페이지 33

{카테고리_이름} Sony MZ-R500에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony MZ-R500 40 페이지. Marketing specifications
Sony MZ-R500에 대해서도 마찬가지입니다: 사용 설명서 (40 페이지), 사용 설명서 (20 페이지), 제한 보증 (1 페이지), 사양 (2 페이지)

페이지 인쇄

Symptom

There is no

recording on the

MD after a

recording

operation.

The lid does not

open.

Volume cannot be

turned up.

No sound comes

through the

headphones/

earphones.

An MD is not

played from the

first track.

Playback sound

skips.

Sound has a lot of

static.

Cannot find the

track marks.

The disc cannot

edit on other

component.

Momentary noise

is heard.

Cause/Solution

• The AC power adaptor was unplugged or a power outage occurred

during recording.

• The battery have been exhausted.

, Replace the exhausted battery with new ones.

• AVLS is on.

, Set AVLS to "OFF" (page 22).

• The headphones/earphones plug is not firmly connected.

, Plug in the plug of the headphones/earphones firmly to i.

• Volume is too low.

, Adjust the volume by pressing VOL +/–.

• Disc playing stopped before it came to the last track.

, Press . repeatedly or open and close the lid once to go back

to the beginning of the disc, and restart playing after checking

the track number in the display.

• The recorder is placed where it receives continuous vibration.

, Put the recorder on a stable place.

• A very short track may cause sound to skip.

• Strong magnetism from a television or such device is interfering

with operation.

, Move the recorder away from the source of strong magnetism.

• You pressed X after pressing . or >.

, Press X before or pressing . or > (page 27).

• The component does not support LP2 and LP4.

, Edit on other component that support LP2 and LP4.

• Due to the special digital audio compression technology used in

LP4 mode, momentary noise may occur on very rare occasions

with certain sound sources.

, Record in normal stereo or LP2 mode.

-GB