Sony RDH-GTK37iP 사용 설명서 - 페이지 19
{카테고리_이름} Sony RDH-GTK37iP에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony RDH-GTK37iP 36 페이지. Personal audio system
Sony RDH-GTK37iP에 대해서도 마찬가지입니다: 제한 보증 (1 페이지), 사양 (4 페이지)
페이지 인쇄
x For an NFC-compatible
smartphone
Touch the smartphone to the N-Mark on
the system to establish the Bluetooth
connection.
Start playback of an audio source on the
smartphone. For details on playback, refer
to the operating instructions of your
smartphone.
To disconnect the Bluetooth device
x For a Bluetooth device
Press BLUETOOTH on the unit.
"BT AUDIO" appears in the display
panel.
Depending on the Bluetooth device, the
Bluetooth connection may be canceled
automatically when you stop playback.
x For an NFC-compatible
smartphone
Touch the smartphone to the N-Mark on
the system again.
Erasing all the pairing
registration information
Use the buttons on the unit to perform this
operation.
1
Press BLUETOOTH to select
Bluetooth function.
"BT AUDIO" appears in the display
panel.
If the system is connected to a
Bluetooth device, the Bluetooth device
name appears in the display panel.
Press BLUETOOTH to disconnect the
Bluetooth device.
2
When holding down x, press
"/1 for about 3 seconds.
"BT HIST" and "CLEAR" appear in
the display panel and all the pairing
information is erased.
Setting the Bluetooth
audio codecs
You can select the Bluetooth audio codecs
when the connected Bluetooth device
supports Advanced Audio Coding
(AAC).
1
Press OPTIONS.
2
Press
/
repeatedly to select
"BT AAC", then press
3
Press
/
repeatedly to select
"ON" or "OFF".
• ON: Advanced Audio Coding
(AAC) is selected if the Bluetooth
device supports AAC.
• OFF: Sub Band Codec (SBC) is
selected.
Notes
• You can enjoy high quality sound if the AAC
is selected. In case you cannot listen to AAC
sound from your device, select "OFF".
• If you change this setting while the system is
connected to a Bluetooth device, the
Bluetooth device will be disconnected. To
connect to the Bluetooth device, perform the
Bluetooth connection again.
Setting/Canceling
Bluetooth standby
mode
The system goes into Bluetooth standby
mode and waits for a Bluetooth
connection, even when the system is
turned off.
1
Press OPTIONS.
2
Press
/
repeatedly to select
"BT STBY", then press
.
.
19
GB