Sony SS-GN800 사용 설명서 - 페이지 15
{카테고리_이름} Sony SS-GN800에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony SS-GN800 36 페이지. Mini hi-fi component system
Sony SS-GN800에 대해서도 마찬가지입니다: 서비스 매뉴얼 (4 페이지)
페이지 인쇄
Other Operations
To
Do this
Tune in a station
Follow the procedure described
with a weak signal
in "Setting presets through
manual tuning".
Set another
Start over from step 1. After step
station to an
3, press > or . (or
existing preset
PRESET + or – on the remote)
number
repeatedly to select the preset
number you want to store the
other station.
To improve tuner reception
When the tuner reception is poor, set the CD power
manage function to "CD POWER OFF". The default
setting is "CD POWER ON".
1
Press CD.
2
Press @/1 to turn off the system.
3
Press @/1 while holding x. "CD
POWER OFF" appears.
To reset to "CD POWER ON"
Repeat the procedure above.
Notes
• When "CD POWER OFF" is selected, the CD
access time is increased.
• You cannot change the setting in Power Saving
Mode.
To change the AM tuning interval
(Except Middle Eastern models)
The factory settings for AM tuning interval is 9 kHz
(10 kHz in some areas). To change the AM tuning
interval, select any AM station first, then turn off the
power. While holding down the AMP MENU button,
turn the power back on. When you change the
interval, AM preset stations will be erased. To reset
the interval, repeat the same procedure.
Tips
• The preset stations are retained for half a day even
if you unplug the power cord or if a power failure
occurs.
• If you press TUNER/BAND while the power is off,
the power turns on automatically and TUNER is
selected as a function.
Listening to the radio
You can listen to a radio station either by
selecting a preset station, or by manually tuning
in the station.
Listening to a preset station
–– Preset Tuning
Before tuning to preset stations, be sure to
preset them (see "Presetting radio stations"
on page 14).
1
Press TUNER/BAND repeatedly to
select "FM" or "AM".
2
Press > or . (or PRESET
+ or – on the remote) repeatedly to tune
in the preset station you want.
Preset number
Listening to non-preset radio
station
— Manual Tuning
1
Press TUNER/BAND repeatedly to
select "FM" or "AM".
2
Press M or m (or TUNING + or – on
the remote) repeatedly to tune in the
station you want.
Tips
• To improve broadcast reception, adjust the supplied
antennas.
• When an FM stereo program has static noise, press
FM MODE repeatedly until "MONO" appears.
There will be no stereo effect, but the reception will
improve.
• Press and hold M or m (or TUNING + or – on
the remote). The frequency indication changes and
scanning stops when the system tunes in a station
(Automatic Tuning).
• To record from the radio, see "Recording to a tape"
on page 17 or "Timer-recording radio programs" on
page 18.
MHC-GN800 4-244-569-13 (3)
Frequency
GB
15