Sony SS-SHAKE33 사용 설명서 - 페이지 39

{카테고리_이름} Sony SS-SHAKE33에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony SS-SHAKE33 48 페이지. Home audio system
Sony SS-SHAKE33에 대해서도 마찬가지입니다: 서비스 매뉴얼 (10 페이지)

페이지 인쇄

• If the transfer and erase operations are

repeated multiple times, the file

structure within the USB device

becomes fragmented. Refer to the

operating instructions supplied with the

USB device on how to deal with this

problem.

• The USB device was disconnected or

the power was turned off during

transfer. Delete the partially-transferred

file, and perform the transfer again. If

this does not fix the problem, the USB

device may be broken. Refer to the

operating instructions of the USB

device on how to deal with this problem.

Audio files or folders on the USB

device cannot be erased.

• Check if the USB device is write-

protected.

• The USB device was disconnected or

the power was turned off during the

erase operation. Delete the partially-

erased file. If this does not fix the

problem, the USB device may be

broken. Refer to the operating

instructions of the USB device on how

to deal with this problem.

There is no sound.

• The USB device is not connected

correctly. Turn off the system and

reconnect the USB device, then turn on

the system and check if "USB A" or

"USB B" lights up in the display panel.

There is noise, skipping, or distorted

sound.

• You are using an unsupported USB

device. Check the information on the

website about compatible USB devices

(page 36).

• Turn off the system and reconnect the

USB device, then turn on the system.

• The music data itself contains noise, or

the sound is distorted. Noise may have

entered during the transfer process.

Delete the file, and try transfer again.

• The bit rate used when encoding audio

files was low. Send audio files with

higher bit rate to the USB device.

"READING" is displayed for an

extended time, or it takes a long time

before playback starts.

• The reading process can take a long time

in the following cases.

– There are many folders or files on the

USB device (page 18).

– The file structure is extremely

complex.

– The memory capacity is excessive.

– The internal memory is fragmented.

"OVER CURRENT" appears.

• A problem has been detected with the

level of electrical current from the

port or

B port. Turn off the system

and remove the USB device from the

port. Make sure there is no problem with

the USB device. If this display pattern

persists, contact your nearest Sony

dealer.

Erroneous display.

• The data stored in the USB device may

have been corrupted, perform the

transfer again.

• The character codes that can be

displayed by this system are as follows:

– Upper cases (A to Z)

– Numbers (0 to 9)

– Symbols (< > * +, [ ] \ _)

Other characters appear as "_".

The USB device is not recognized.

• Turn off the system and reconnect the

USB device, then turn on the system.

• Check the information on the website

about compatible USB devices

(page 36).

• The USB device does not work

properly. Refer to the operating

instructions of the USB device on how

to deal with this problem.

Playback does not start.

• Turn off the system and reconnect the

USB device, then turn on the system.

• Check the information on the website

about compatible USB devices

(page 36).