Cisco ASA 5540 빠른 시작 매뉴얼 - 페이지 17

{카테고리_이름} Cisco ASA 5540에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASA 5540 40 페이지. Asa 5500 series adaptive security appliance

Chapter 3

Installing the ASA 5550

Cable Holder

4 Rubber Feet

Powering On the ASA

Step 1

Step 2

Step 3

Step 4

Step 5

Connecting Interface Cables and Verifying

Connectivity

Step 1

Step 2

78-19753-01

Attach the power cable to the rear panel of the ASA.

Connect the power cable to an electrical outlet.

Power on the ASA.

Check the Power LED on the front of the ASA; if it is solid green, the device is

powered on.

Check the Status LED on the front of the ASA; once it is solid green, the system

has passed power-up diagnostics.

Connect a management PC to the Management 0/0 interface for use with the

Adaptive Security Device Manager (ASDM).You can connect it directly with an

Ethernet cable, or connect the PC and the ASA to the same management network.

Make sure the PC is configured to obtain an IP address using DHCP.

If you want to use the CLI, connect your PC to the console port and see

Note

the CLI configuration guide more information.

Connect your networks to the appropriate ports. If you are using the fiber ports,

you need an SFP module. See the Cisco ASA 5500 Series Hardware Installation

Guide for information.

4 Cap Screws

10 Documentation

Cisco ASA 5500 Series Quick Start Guide

Powering On the ASA

3-3