Sony STR-DH130 사용 설명서 - 페이지 32
{카테고리_이름} Sony STR-DH130에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony STR-DH130 35 페이지. Fm stereo / fm-am receiver
Sony STR-DH130에 대해서도 마찬가지입니다: 사용 설명서 (36 페이지), 빠른 설정 매뉴얼 (2 페이지), 사양 (2 페이지), 제한 보증 (1 페이지), 서비스 매뉴얼 (36 페이지), 서비스 매뉴얼 (36 페이지)
페이지 인쇄
The remote control does not function.
• Point the remote control at the remote
control sensor on the receiver.
• Remove any obstacles in the path between
the remote control and the receiver.
• Replace all the batteries in the remote
control with new ones, if they are weak.
• Make sure you select the correct input on
the remote control.
If there is a malfunction, a message appears on
the display panel. You can check the condition
of the system by the message. If any problem
persists, consult your nearest Sony dealer.
PROTECT
Irregular current is output to the speakers, or
the receiver is covered and ventilation holes
are blocked. The receiver will automatically
turn off alter a few seconds. Check the
speaker connection and turn on the power
again.
.....
Reference section
To clear
See
All memorized settings
page 18
Specifications
AUDIO POWER
SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
(USA model only)
With 8 ohm loads, both channels driven, from
20 - 20,000 Hz; rated 90 watts per channel
minimum RMS power, with no more than
0.09% total harmonic distortion from 250
milliwatts to rated output.
Amplifier section
USA, Canada and Europe models 1)
Minimum RMS Output Power (8 ohms, 20 Hz -
20 kHz, THD 0.09%)
90W+90W
Stereo Mode Output Power (8 ohms, 1 kHz,
THD 1%)
100W+ 100W
l)Measured
under
the following
conditions:
Area
Power
requirements
USA,
Canada
120 V AC, 60 Hz
Europe
230 V AC, 50 Hz
Frequency
response
Analog
10 Hz - 70 kHz
+0.5/-9_ dB (with BASS =
0 dB, TREBLE
= 0 dB)
Input
Analog (PORTABLE
IN)
Sensitivity:
1 V/
50 kilohms
S/N2): 96 dB (A, 500 mV 3)
Inputs
Analog (Except PORTABLE
IN)
Sensitivity:
500 mV/
50 kilohms
S/N2): 96 dB (A, 500 mV 3)
Outputs
Analog (AUDIO OUT)
Voltage: 500 mV/
10 kilohms
32_8