Sony STR-DN1030 빠른 설정 매뉴얼 - 페이지 13
{카테고리_이름} Sony STR-DN1030에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony STR-DN1030 16 페이지. Multi channel av receiver
Sony STR-DN1030에 대해서도 마찬가지입니다: 빠른 설정 매뉴얼 (2 페이지), 제한 보증 (1 페이지)
페이지 인쇄
If an error code or warning appears on the TV
screen after Auto Calibration, look it up below.
After taking the appropriate steps, perform Auto
Calibration again.
Error Code 31
No speakers are selected. Press SPEAKERS to set
the speakers.
Error Code 32
Error Code 33
ē None of the front speakers are connected, or
ē
only one front speaker is connected.
ē The optimizer microphone is not connected.
ē
ē The surround left or surround right speaker is
ē
not connected.
ē Surround back speakers or front high speakers
ē
are connected even though surround speakers
are not connected. Connect surround
speaker(s) to the SPEAKERS SURROUND
terminals.
ē A single surround back speaker is connected
ē
to the SPEAKERS SURROUND BACK/FRONT
HIGH/BI-AMP/FRONT B R terminal. When you
connect only one surround back speaker,
connect it to the SPEAKERS SURROUND BACK/
FRONT HIGH/BI-AMP/FRONT B L terminal.
ē The front left high or front right high speaker
ē
is not connected.
ē None of the speakers were detected. Make
ē
sure that the optimizer microphone is
connected properly. If it is connected properly
but the error code still appears, the optimizer
microphone cable may be damaged.
Warning 40
The measurement process has completed
with high noise level detection. Perform the
measurement in a quiet environment.
Warning 41/Warning 42
ē The input from the optimizer microphone is
ē
too loud.
ē The distance between the speakers and the
ē
optimizer microphone is too close. Set them
farther apart.
Warning 43
The distance and position of a subwoofer cannot
be detected. Perform the measurement in a
quiet environment.
No Warning
There is no warning information.
13