Sony WX-900BT 사용 설명서 - 페이지 25

{카테고리_이름} Sony WX-900BT에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony WX-900BT 37 페이지. Bluetooth audio system
Sony WX-900BT에 대해서도 마찬가지입니다: 사용 설명서 (20 페이지)

페이지 인쇄

The N-Mark is a trademark or registered trademark

of NFC Forum, Inc. in the United States and in other

countries.

Windows Media is either a registered trademark or

trademark of Microsoft Corporation in the United

States and/or other countries.

This product is protected by certain intellectual

property rights of Microsoft Corporation. Use or

distribution of such technology outside of this

product is prohibited without a license from

Microsoft or an authorized Microsoft subsidiary.

iPhone, iPod, iPod classic, iPod nano, iPod touch,

and Siri are trademarks of Apple Inc., registered in

the U.S. and other countries. App Store is a service

mark of Apple Inc.

MPEG Layer-3 audio coding technology and patents

licensed from Fraunhofer IIS and Thomson.

Pandora®, the Pandora® logo, and the Pandora®

trade dress are trademarks or registered

trademarks of Pandora Media, Inc., used with

permission.

Google, Google Play and Android are trademarks of

Google Inc.

libFLAC

Redistribution and use in source and binary forms,

with or without modification, are permitted

provided that the following conditions are met:

 Redistributions of source code must retain the

above copyright notice, this list of conditions and

the following disclaimer.

 Redistributions in binary form must reproduce

the above copyright notice, this list of conditions

and the following disclaimer in the

documentation and/or other materials provided

with the distribution.

 Neither the name of the Xiph.org Foundation nor

the names of its contributors may be used to

endorse or promote products derived from this

software without specific prior written

permission.

THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT

HOLDERS AND CONTRIBUTORS "AS IS" AND ANY

EXPRESS OR IMPLIED WARRANTIES, INCLUDING,

BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF

MERCHANTABILITY AND FITNESS FOR A

PARTICULAR PURPOSE ARE DISCLAIMED. IN NO

EVENT SHALL THE FOUNDATION OR CONTRIBUTORS

BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL,

SPECIAL, EXEMPLARY, OR CONSEQUENTIAL

DAMAGES (INCLUDING, BUT NOT LIMITED TO,

PROCUREMENT OF SUBSTITUTE GOODS OR

SERVICES; LOSS OF USE, DATA, OR PROFITS; OR

BUSINESS INTERRUPTION) HOWEVER CAUSED AND

ON ANY THEORY OF LIABILITY, WHETHER IN

CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING

NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY

OUT OF THE USE OF THIS SOFTWARE, EVEN IF

ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.

Troubleshooting

The following checklist will help you remedy

problems you may encounter with your unit.

Before going through the checklist below, check

the connection and operating procedures.

For details on using the fuse and removing the unit

from the dashboard, see "Connection/Installation"

(page 31).

If the problem is not solved, visit the support site on

the back cover.

General

No power is being supplied to the unit.

 If the unit is turned off and the display

disappears, the unit cannot be operated with the

remote commander.

 Turn on the unit.

No sound or the sound is very low.

 The position of the fader control [FADER] is not

set for a 2-speaker system.

 The volume of the unit and/or connected device

is very low.

 Increase the volume of the unit and connected

device.

No beep sound.

 An optional power amplifier is connected and

you are not using the built-in amplifier.

The contents of the memory have been erased.

 The reset button has been pressed.

 Store again into the memory.

 The power supply lead or battery has been

disconnected or not connected properly.

Stored stations and correct time are erased.

The fuse has blown.

Makes a noise when the position of the ignition

is switched.

 The leads are not matched correctly with the car's

accessory power connector.

During playback or reception, the demonstration

mode starts.

 If no operation is performed for 5 minutes with

[DEMO-ON] set, the demonstration mode starts.

 Set [DEMO-OFF] (page 18).