Sony ZS-S10CP 지침 및 운영 매뉴얼 - 페이지 2
{카테고리_이름} Sony ZS-S10CP에 대한 지침 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony ZS-S10CP 2 페이지. Personal audio system
Sony ZS-S10CP에 대해서도 마찬가지입니다: 사용 설명서 (2 페이지), 시작 매뉴얼 (2 페이지), 서비스 매뉴얼 (40 페이지)
페이지 인쇄
Other Operations
Using the display
Creating your own program
Play)
You can check information about the CD using the
display.
You can arrange the playing order of up to 20 tracks/
MP3 files on a CD.
Checking the information of an audio CD
1
Press OPERATE (or POWER)
To check the total track number and playing
2
Press CD
time of the CD
3
Press MODE (press , then press MODE
After reading the CD, the total playing time will
during playback) until "PGM" appears in the
appear, or press
twice to cancel Resume play.
display.
4
Press
Total playing time
For MP3 files, press
then press
Checking the information of an MP3 disc
Track (File) number flashes in the display.
Audio CD
To check the total folder/file number and total
file number on the CD
After reading the folder/file information, the total
folder number and the file number will appear, or
press
twice to cancel Resume play.
MP3 disc
Total folder number
Total file number
5
Press DISPLAY/ENTER
Playing tracks/MP3 files repeatedly
"P-xx" appears in the display.
(Repeat Play)
Audio CD
You can play tracks/MP3 files repeatedly in normal
and program play modes.
1
Press OPERATE (or POWER)
.
2
Press CD
.
MP3 disc
3
Proceed as follows, while CD/MP3 disc is not
playing.
To repeat
Do this
6
A single
1 Press MODE (press , then
To program another song, repeat steps 4 and 5.
press MODE during playback) until
track/MP3
7
Press
file
"
1" appears.
2 Press
or
to select the
To cancel Program Play
track/MP3 file that you want to repeat.
Stop playback first. Then press MODE
3 Press
.
disappears from the display.
All tracks/
1 Press MODE (press , then
press MODE during playback) until
MP3 files
To check the order of tracks/MP3 files
on the CD
" " appears.
Press DISPLAY/ENTER
2 Press
.
DISPLAY/ENTER
1 Press MODE (press , then
A selected
The last programmed step number appears in the
folder (MP3
press MODE during playback) until
display. After a few seconds, the last programmed
disc only)
" " and " " appear.
track/folder number appears in the display.
2 Select the folder by pressing
/TUNE
To change the current program
+ or – .
3 Press
.
Press
if the CD is playing. The current program will be
Programmed
1 Program tracks/MP3 files (see
erased. Then create a new program following the
"Creating your own program").
tracks/MP3
programming procedure.
files
2 Press MODE (press , then
press MODE during playback) until
Tips
"PGM" and " " appear.
If you try to program 21 tracks/MP3 files or more, "FULL" will
.
appear in the display.
3 Press
You can play the same program again, since the program is
saved until you open the CD compartment.
Note
The resume function does not work during Program Play.
You cannot change the play mode while a track/MP3 file is
playing or paused.
When you press MODE during playback, "PUSH STOP"
appears in the display.
Presetting radio stations
To cancel Repeat Play
You can store radio stations into the unit's memory.
Press MODE (press , then press MODE
You can preset up to 30 radio stations, 20 for FM and
during playback) until " " disappears from the
10 for AM in any order.
display.
1
Press OPERATE (or POWER)
2
Press RADIO BAND
Playing tracks/MP3 files in random
3
Hold down AUTO PRESET
order
"AUTO" flashes in the display.
(Shuffle Play)
4
Press DISPLAY/ENTER
You can play tracks/MP3 files in random order.
The stations are stored in memory from the lower
1
Press OPERATE (or POWER)
.
frequencies to the higher ones.
2
Press CD
.
If a station cannot be preset automatically
3
Press MODE
(press
, then press MODE
You need to preset a station with a weak signal
during playback) until "SHUF" appears in the
manually.
display.
1
Press OPERATE (or POWER)
4
Press
to start Shuffle Play.
2
Press RADIO BAND
To cancel Shuffle Play
3
Tune in a station you want using
Stop playing first. Then press MODE
(press
,
–
.
then press MODE
during playback) until "SHUF"
4
Press MANUAL PRESET
disappears from the display.
The band selected ("FM-xx" or "AM-xx") appears in
Note
the display.
You cannot change the play mode while a track/MP3 file is
5
Press PRESET + or –
playing or paused.
When you press MODE during playback, "PUSH STOP"
want for the station flashes in the display.
appears in the display.
6
Press DISPLAY/ENTER
Tips
The new station replaces the old one.
During Shuffle Play, you cannot select the previous track/MP3
file by pressing
.
Tip
The resume function does not work during Shuffle Play.
The preset radio stations remain in memory even if you unplug
the AC power cord or remove the batteries.
Playing preset radio stations
(Program
1
Press OPERATE (or POWER)
2
Press RADIO BAND
3
Press PRESET + or –
.
station.
.
Connecting optional components
You can enjoy the sound from an optional component
or
to select the track.
such as a portable digital music player through the
/TUNE + or – first and
speakers of this unit. Be sure to turn off the power
.
or
of each component before making any connections.
For details, refer to the instruction manual of the
component to be connected.
1
Connect the AUDIO IN jack
jack of the portable digital music player or other
components using an audio connecting cable (not
supplied).
2
Press OPERATE (or POWER)
3
Turn the connected component on.
4
Press AUDIO IN
connected component.
The sound from the connected component is
output from the speakers of this unit.
.
To connect the unit to a TV or VCR, use an
extension cable (not supplied) with a stereo-mini
jack on one end and two phono plugs on the other
end.
to start Program Play.
until "PGM"
(press
, then press
during playback).
once if the CD is stopped and twice
.
to select the band.
for 2 seconds until
.
.
to select the band.
/TUNE + or
.
until the preset number you
.
Precautions
Discs that this unit CAN play
• Audio CD
• CD-R/CD-RW (CD-DA*/MP3 files)
.
* CD-DA is the abbreviation for Compact Disc Digital Audio. It is a
recording standard used for Audio CDs.
to select the band.
Discs that this unit CANNOT play
to tune in the stored
• CD-R/CD-RW other than those recorded in music CD
format or MP3 format conforming to ISO9660 Level
1/Level 2 or Joliet
• CD-R/CD-RW of poor recording quality, CD-R/CD-RW
that has scratches or is dirty, or CD-R/CD-RW recorded
with an incompatible recording device
• CD-R/CD-RW which is finalized incorrectly
Notes on discs
• Before playing, clean the CD
with a cleaning cloth. Wipe the
CD from the center out. If there
to the line output
is a scratch, dirt or fingerprints
on the CD, it may cause tracking
error.
to turn the unit on.
• Do not use solvents such as benzine, thinner,
commercially available cleaners or anti-static spray
intended for vinyl LPs.
, and start playback on the
• Do not expose the CD to direct sunlight or heat
sources such as hot air ducts, or leave it in a
car parked in direct sunlight as there can be a
considerable rise in temperature inside the car.
• Do not stick paper or a sticker on the CD, or scratch
the surface of the CD.
• After playing, store the CD in its case.
On safety
• As the laser beam used in the CD player section is
harmful to the eyes, do not attempt to disassemble
the casing. Refer servicing to qualified personnel
only.
• Should any solid object or liquid fall into the unit,
unplug the unit, and have it checked by qualified
personnel before operating it any further.
• Discs with non-standard shapes (e.g., heart, square,
star) cannot be played on this unit. Attempting to
do so may damage the unit. Do not use such discs.
On power sources
• For AC operation, check that the unit's operating
voltage is identical with your local power supply
(see "Specifications") and use the supplied AC
power cord; do not use any other type.
• Unplug the unit from the wall outlet when it is not
be used for an extended period of time.
• If the batteries are not to be used, remove them
to avoid damage that can be caused by battery
leakage or corrosion.
On placement
• Do not leave the unit in a location near heat sources,
in a place subject to direct sunlight, excessive dust
or mechanical shock, or in a car subject to the direct
rays of the sun.
• Do not place the unit on an inclined or unstable
place.
• Do not place anything within 10 mm of the side
of the cabinet. The ventilation holes must be
unobstructed for the unit to operate properly and
prolong the life of its components.
• Since a strong magnet is used for the speakers,
keep personal credit cards using magnetic coding
or spring-wound watches away from the unit to
prevent possible damage from the magnet.
On operation
• If the unit is brought directly from a cold to a warm
location, or is placed in a very damp room, moisture
may condense on the lens inside the CD player
section. Should this occur, the unit will not operate
properly. In this case, remove the CD and wait about
an hour for the moisture to evaporate.
• The design of the carrying handle prohibits you from
lifting it forcibly while the CD compartment is open.
Cleaning the cabinet
• Clean the cabinet, panel and controls with a soft
cloth slightly moistened with a mild detergent
solution. Do not use any type of abrasive pad,
scouring powder, or solvent, such as alcohol or
benzine.
If you have any questions or problems concerning
your unit, please consult your nearest Sony dealer.
Troubleshooting
General
The power does not turn on.
Connect the AC power cord to the wall outlet
securely.
Make sure the batteries are inserted correctly.
Replace all the batteries with new ones if they are
weak.
There is no audio.
Unplug the headphones when listening through
speakers.
Noise is heard.
Someone is using a portable telephone or other
equipment that emits radio waves near the unit.
Move the portable telephone, etc., away from
the unit.
CD/MP3 player
The CD does not play or "noDISC" is displayed
even when a CD is in place.
Place the CD with the label surface up.
Clean the CD.
Take out the CD and leave the CD compartment
open for about an hour to dry moisture
condensation.
The CD-R/CD-RW is blank.
There is a problem with the quality of the CD-R/
CD-RW, recording device or application software.
Replace all the batteries with new ones if they are
weak.
The sound drops out.
Reduce the volume.
Clean the CD, or replace it if the CD is badly
damaged.
Place the unit in a location free from vibration.
Clean the lens with a commercially available blower.
The sound may drop out or noise may be heard
when using a poor quality CD-R/CD-RW or if there is
a problem with the recording device or application
software.
Starting playback takes more time than usual.
The following discs take a longer time to start
playback.
– a disc recorded with a complicated tree structure.
– a disc that has not been finalized (a disc to which
data can be added).
– a disc that has many folders or non-MP3 files.
Radio
Reception is poor.
Reorient the
antenna to
improve FM
reception.
Reorient the unit
itself to improve
AM reception.
The audio is weak or is poor quality.
Replace all the batteries with new ones if they are
weak.
Move the unit away from the TV.
If you are using the remote while listening to AM
radio, noise may be heard.
The TV picture becomes unstable.
If you are listening to an FM program near the TV
with an indoor antenna, move the unit away from
the TV.
After trying the remedies, if you still have problems,
unplug the AC power cord or remove all the batteries.
After all the indications in the display disappear, plug
the AC power cord back in, or insert the batteries
again. If the problem persists, please consult your
nearest Sony dealer.
Carrying handle