Cisco ASA 5545-X 빠른 시작 매뉴얼 - 페이지 9

{카테고리_이름} Cisco ASA 5545-X에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASA 5545-X 15 페이지. Threat defense reimage guide
Cisco ASA 5545-X에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (13 페이지), 빠른 시작 매뉴얼 (13 페이지), 소프트웨어 설명서 (37 페이지)

페이지 인쇄

Cisco ASA 5512-X, ASA 5515-X, ASA 5525-X, ASA 5545-X, and ASA 5555-X Quick Start Guide

object network obj_any

subnet 0 0

nat (any,outside) dynamic interface

http server enable

http 192.168.1.0 255.255.255.0 inside

dhcpd address 192.168.1.5-192.168.1.254 inside

dhcpd auto_config outside

dhcpd enable inside

logging asdm informational

Save the new configuration:

write memory

Cable the following:

Management Computer

DHCP from ASA: 192.168.1.x

Management 0/0

192.168.1.2

(Module management)

Cable the following to a Layer 2 Ethernet switch:

—

GigabitEthernet 0/1 interface (inside)

—

Management 0/0 interface (for the module)

—

Your computer

Note:

You can connect inside and management on the same network because the management interface acts like a separate

device that belongs only to the ASA FirePOWER module.

Connect the outside GigabitEthernet 0/0 interface to your upstream router or WAN device.

Note:

If the cable modem supplies an outside IP address that is on 192.168.1.0/24 or 192.168.10.0/24, then you must change

the ASA configuration to use a different IP address. Interface IP addresses, HTTPS (ASDM) access, and DHCP server settings

can all be changed using the Startup Wizard. If you change the IP address to which you are connected to ASDM, you will be

disconnected when you finish the wizard. You must reconnect to the new IP address.

Cisco ASA 5512-X, ASA 5515-X, ASA 5525-X, ASA 5545-X, and ASA 5555-X Quick Start Guide

4. Modify the Initial Configuration for the ASA FirePOWER Module (Optional)

Layer 2 Switch

GigabitEthernet 0/0

outside, DHCP from modem

GigabitEthernet 0/1

inside, 192.168.1.1

(ASA management; Gateway)

Internet

WAN Modem