ACU-RITE Mill PWR G2 소프트웨어 업데이트

{카테고리_이름} ACU-RITE Mill PWR G2에 대한 소프트웨어 업데이트을 온라인으로 검색하거나 PDF를 다운로드하세요. ACU-RITE Mill PWR G2 3 페이지.
ACU-RITE Mill PWR G2에 대해서도 마찬가지입니다: 소프트웨어 업데이트 (7 페이지), 소프트웨어 업데이트 (3 페이지), 소프트웨어 업데이트 (5 페이지), 소프트웨어 업데이트 (5 페이지), 소프트웨어 업데이트 (6 페이지), 소프트웨어 업데이트 (5 페이지), 소프트웨어 업데이트 (3 페이지), 소프트웨어 업데이트 (6 페이지)

NOTE: HEIDENHAIN Corporation recommends making a backup of the control with the

included USB Recovery Drive before updating the control software. Please refer to the manual

included with the drive for the backup procedure

R4SP4 is a complete software update.

If a special PLC for AMI functions was created for your MILLPWR system this may need to be

reinstalled after completing the R4SP4 update.

AMI or users of auxiliary machine function interface will need to first check two configuration

settings in their current system.

Make note of the values so that they can be restored manually after the R4SP4 update, via the

Machine Functions menu.

The special password provided or setup by your authorized dealer to access the Advanced

Configuration from Installation Setup is required in order to view these settings:

System -> PLC -> CfgOemBool -> NP_MG_guard_inactive – [value]

If the setting is FALSE, then in R4SP1 they should set "Guards" to "Enabled"

Axes -> ParameterSets -> PS_1 -> CfgAxisAnalog – [unipolar]

If the setting is "off", then in R4SP4 they should set "Polarity" to "Bipolar"

To verify your software version, from the DRO screen press SETUP. If one of your soft keys is

labeled More Commands, you have release 1 (R1) software. If one of your soft keys is labeled

Install Setup, press this key. Enter the password 8891 and press Enter. The installed software

version will be displayed at the bottom left of your screen.

If any issues are encountered, please contact your service representative for assistance.

You can download the software release update from our web site at www.acu-rite.com. If you

wish to purchase the software and operation manual from ACU-RITE, contact Customer Service

to place an order.

Installing the software onto your MILLPWR

Use a blank USB memory stick (1 GB or larger) to update the software. Do not use any memory

stick with a smaller storage capacity. The software installation files are required for updating the

software. When a USB memory device in placed in a USB port prior to boot up with the update

files setup.zip, and setup.ini located within a folder named "install", at boot up your G2 control

will detect the upgrade software files and proceed to install.

Release of Version R4SP4

system:

October 27, 2016

MILLPWR

2 & 3 Axis