Cisco ASR 9000 Series 네트워크 설정 구성 - 페이지 14

{카테고리_이름} Cisco ASR 9000 Series에 대한 네트워크 설정 구성을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASR 9000 Series 26 페이지. Line card
Cisco ASR 9000 Series에 대해서도 마찬가지입니다: 구성 매뉴얼 (46 페이지), 구성 매뉴얼 (50 페이지), 매뉴얼 (24 페이지), 구성 (46 페이지), 매뉴얼 (44 페이지), 빠른 참조 매뉴얼 (7 페이지)

페이지 인쇄

Implementing a Satellite nV System

Command or Action

Step 7

satellite-fabric-link satellite <id>

Example:

RP/0/RSP0/CPU0:router(config-int-nv)#

satellite-fabric-link satelite 200

Step 8

remote-ports interface type

Example:

RP/0/RSP0/CPU0:router(config-int-nv)#

remote-ports GigabitEthernet 0/0/0-30

Step 9

end

commit

Example:

RP/0/RSP0/CPU0:router(config)# end

RP/0/RSP0/CPU0:router(config)# commit

Note

For information on QoS configuration on ICLs , see Cisco ASR 9000 Series Aggregation Services Router

Modular Quality of Service Configuration Guide.

Configuring the Satellite nV Access Interfaces

The access GigabitEthernet interfaces on the satellite are represented locally in Cisco IOS XR Software

using interfaces named GigabitEthernet similar to other non-satellite GigabitEthernet interfaces. The

only difference is that the rack id used for a satellite access GigabitEthernet interface is the configured

satellite ID for that satellite.

These interfaces support all features that are normally configurable on GigabitEthernet interfaces (if

running over a physical IC Link), or Bundle-Ether interfaces (if running over a virtual IC Link).

Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Configuration Guide

HC-720

Configuring the Satellite Network Virtualization (nV) System on the Cisco ASR 9000 Series Router

Purpose

Specifies that the interface is an ICPE inter-chassis link.

Configures the remote satellite ports 0 to 30.

Saves configuration changes.

•

When you issue the end command, the system prompts you to

commit changes:

Uncommitted changes found, commit them before

exiting(yes/no/cancel)?

[cancel]:

–

Entering yes saves configuration changes to the running

configuration file, exits the configuration session, and

returns the router to EXEC mode.

Entering no exits the configuration session and returns the

–

router to EXEC mode without committing the

configuration changes.

Entering cancel leaves the router in the current

–

configuration session without exiting or committing the

configuration changes.

•

Use the commit command to save the configuration changes to

the running configuration file and remain within the

configuration session.

OL-26061-03