Cisco ASR 9000 Series 구성 매뉴얼 - 페이지 19

{카테고리_이름} Cisco ASR 9000 Series에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASR 9000 Series 50 페이지. Line card
Cisco ASR 9000 Series에 대해서도 마찬가지입니다: 네트워크 설정 구성 (26 페이지), 구성 매뉴얼 (46 페이지), 매뉴얼 (24 페이지), 구성 (46 페이지), 매뉴얼 (44 페이지), 빠른 참조 매뉴얼 (7 페이지)

페이지 인쇄
Cisco ASR 9000 Series 구성 매뉴얼
Configuring Serial Interfaces on the Cisco ASR 9000 Series Router
Command or Action
Step 6
end
or
commit
Example:
RP/0/0RP0RSP0/CPU0:router (config-if)# end
or
RP/0/0RP0RSP0/CPU0:router(config-if)# commit
Step 7
exit
Example:
RP/0/0RP0RSP0/CPU0:router (config-if)# exit
Step 8
exit
Example:
RP/0/0RP0RSP0/CPU0:router (config)# exit
Step 9
show interfaces
configure
interface serial interface-path-id
no shut
exit
exit
Example:
RP/0/0RP0RSP0/CPU0:router# show interfaces
RP/0/0RP0RSP0/CPU0:router# configure
RP/0/0RP0RSP0/CPU0:router (config)# interface
serial 0/1/0/1
RP/0/0RP0RSP0/CPU0:router(config-if)# ipv4
address 10.1.2.2 255.255.255.224
RP/0/0RP0RSP0/CPU0:router (config-if)# no
shutdown
RP/0/0RP0RSP0/CPU0:router (config-if)# commit
RP/0/0RP0RSP0/CPU0:router (config-if)# exit
RP/0/0RP0RSP0/CPU0:router (config)# exit
OL-26061-03
Cisco ASR 9000 Aggregation Services Router Interfaces and Hardware Component Configuration Guide
Purpose
Saves configuration changes.
•
When you issue the end command, the system prompts
you to commit changes:
Uncommitted changes found, commit them before
exiting(yes/no/cancel)?
[cancel]:
–
Entering yes saves configuration changes to the
running configuration file, exits the configuration
session, and returns the router to EXEC mode.
Entering no exits the configuration session and
–
returns the router to EXEC mode without
committing the configuration changes.
Entering cancel leaves the router in the current
–
configuration session without exiting or
committing the configuration changes.
Use the commit command to save the configuration
•
changes to the running configuration file and remain
within the configuration session.
Exits interface configuration mode and enters global
configuration mode.
Exits global configuration mode and enters EXEC mode.
Repeat Step 1 through Step 8 to bring up the interface at the
other end of the connection.
The configuration on both ends of the serial
Note
connection must match.
How to Configure Serial Interfaces
517