Cisco ASR 9000 Series 구성 매뉴얼 - 페이지 31
{카테고리_이름} Cisco ASR 9000 Series에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASR 9000 Series 50 페이지. Line card
Cisco ASR 9000 Series에 대해서도 마찬가지입니다: 네트워크 설정 구성 (26 페이지), 구성 매뉴얼 (46 페이지), 매뉴얼 (24 페이지), 구성 (46 페이지), 매뉴얼 (44 페이지), 빠른 참조 매뉴얼 (7 페이지)
페이지 인쇄
Configuring Serial Interfaces on the Cisco ASR 9000 Series Router
After you configure an interface for Layer 2 switching, no routing commands such as ipv4 address are
Note
permissible. If any routing commands are configured on the interface, then the l2transport command is
rejected.
Creating a Serial Layer 2 Subinterface with a PVC
The procedure in this section creates a Layer 2 subinterface with a PVC.
Prerequisites
Before you can create a subinterface on a serial interface, you must bring up a serial interface, as
described in the
Restrictions
Only one PVC can be configured for each serial subinterface.
SUMMARY STEPS
1.
2.
3.
4.
5.
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/0RP0/CPU0:router# configure
Step 2
interface serial interface-path-id
l2transport
Example:
RP/0/0RP0/CPU0:router(config)# interface serial
0/1/0/0.1 l2transport
OL-26061-03
"Bringing Up a Serial Interface" section on page
configure
interface serial interface-path-id.subinterface l2transport
pvc vpi/vci
end
or
commit
Repeat Step 1 through Step 4 to bring up the serial subinterface and any associated PVC at the other
end of the AC.
.
subinterface
Cisco ASR 9000 Aggregation Services Router Interfaces and Hardware Component Configuration Guide
514.
Purpose
Enters global configuration mode.
Creates a subinterface and enters serial subinterface
configuration mode for that subinterface.
How to Configure Serial Interfaces
529