Cisco ASR 9910 매뉴얼 - 페이지 25

{카테고리_이름} Cisco ASR 9910에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASR 9910 44 페이지. Replacing cisco asr 9000 series router components

Replacing Cisco ASR 9000 Series Router Components

Step 3

Install the captive screw in each ejector lever into the screw hole in the power tray frame (figures Rotating

the Ejector Levers Inward to Seat the Version 1 Power Tray or Rotating the Ejector Levers Inward to Seat

the Version 2 Power Tray).

Step 4

Use the 6-inch long number 2 Phillips screwdriver to tighten the two ejector screws to a torque of 10 +/-1

in-lb to secure the ejectors and to secure the tray to its mating connector.

Step 5

Install and tighten two screws through the power tray mounting ears on each side into the screw holes in the

chassis mounting ears to secure the tray to the chassis.

Removing and Replacing Cards from the Chassis

This section describes the procedures for removing and installing an RSP card, RP card, FC, or LC.

See the

information about removing and installing SIP and SPA cards.

• For a information about the router components and slot numbering for the Cisco ASR 9010 Router, Cisco

• For a information about the router components and slot numbering for the Cisco ASR 9922 Router and

• The Cisco ASR 9906 and Cisco ASR 9910 chassis are midplane chassis and the method of removal and

Caution

Handle all cards by the metal card carrier edges only; avoid touching the board or any connector pins. After

removing a card, carefully place it in an antistatic bag or similar environment to protect it from ESD and dust

in the optic ports (fiber-optic line cards).

Caution

Be careful to avoid damaging the EMI gasket that runs along the full height of the card front panel edges.

Damage to the EMI gasket can affect the ability of your system to meet EMI requirements.

Caution

To avoid damaging card mechanical components, never carry an RSP card, RP card, FC, or LC by the captive

installation screws or ejector levers. Doing so can damage these components and cause card insertion problems.

Cisco ASR 9000 Series Aggregation Services Router SIP and SPA Hardware Installation Guide

ASR 9006 Router, and Cisco ASR 9904 Router, see

Cisco ASR 9010 Router, Cisco ASR 9006 Router, Cisco ASR 9904 Router, Cisco ASR 9906 Router,

and Cisco ASR 9910

Router.

Cisco ASR 9912 Router, see

9922 Router and Cisco ASR 9912

replacing cards is different from other routers. The RSP (RSP0, RSP1) cards are located in the front of

the chassis. The 4 line cards on the Cisco ASR 9906 (LC0 - LC3) and 8 line cards on the Cisco ASR

9910 (LC0 - LC7) slots are located in the front of the chassis. The 5 fabric cards (FC0 - FC4) can be

inserted or removed from the rear side of the chassis.

Removing RSP Cards and Line Cards from the

Removing RP Cards, Fabric Cards, and Line Cards from the Cisco ASR

Router.

Replacing Cisco ASR 9000 Series Router Components

Removing and Replacing Cards from the Chassis

for