Cisco ASR 9910 매뉴얼 - 페이지 30

{카테고리_이름} Cisco ASR 9910에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASR 9910 44 페이지. Replacing cisco asr 9000 series router components

Migrating from RP2 to RP3 Card

Step 13

Insert and boot RP2. After booting, the RP2 becomes standby RP. Do not set the ROMMON variable.

Step 14

Repeat Step 7, Step 8 and Step 9.

Step 15

(Optional) Perform FPD upgrade on the RP2. Use these commands:

Example:

Router#(admin) upgrade hw-module fpd all location 0/rsp0/cpu0

Router#(admin) upgrade hw-module fpd all location 0/rsp1/cpu0

Step 16

Clear ROMMON variable for active RP from XR prompt:

Example:

Router# run nvram_rommonvar RSP_LINK_1G 0

Migrating from RP2 to RP3 Card

Before you begin:

• You must have console access to the router. Default console speed on RP3 is set as 115200.

• The router must be running Cisco 64-bit IOS XR software release 6.5.15 or later version. If your router

• The router must have two RP2 cards (active and standby) up and running.

• First and second generation Cisco ASR 9000 Ethernet Line Cards must be removed from the chassis as

Procedure

Step 1

Use the show redundancy summary command to verify that the RP0 and RP1 are in Ready State.

Example:

Router# show redundancy summary

Active/Primary Standby/Backup

-------------- --------------

0/RP0/CPU0(A)

0/RP0/CPU0(P)

Step 2

Shutdown the standby RP2 card (slot 1) using the admin hw-module shutdown location 0/RP1 command.

Replacing Cisco ASR 9000 Series Router Components

is running a 32-bit IOS XR release, you will need to migrate to 64-bit XR release 6.5.15 or later. Refer

Migration Guide for Cisco ASR 9000 Series

Note

RP3 is only supported with 64-bit IOS XR software releases.

they are incompatible with RP3.

0/RP1/CPU0(S) (Node Ready, NSR: Ready)

0/RP1/CPU0(B) (Proc Group Ready, NSR: Ready)

Replacing Cisco ASR 9000 Series Router Components

Routers.