DIGITIZE SEBB-6/24 사용자 설명서 - 페이지 6

{카테고리_이름} DIGITIZE SEBB-6/24에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DIGITIZE SEBB-6/24 11 페이지.

2.4 BACK PANEL

2.5 SEBB-6/24 to BATTERY SETUP

To connect the SEBB-6/24 to the batteries, use the 6 foot red and black cable

with the quick connects end. The Molex 2 position end is attached to the

SEBB-6/24 port marked "TO 24 VOLT SEALED LEAD ACID

BATTERIES".

Connect the AMP QUICK CONNECT ends to the two backup batteries, the

red wire to the positive(+) side of the first battery and the black wire to the

negative(-) side of the second battery. The neutral 12 inch blue wire, is used to

connect the two batteries together. Refer to DWG 2.

NOTE: If there is a charge on the batteries, this will activate the SEBB-6/24,

and the display will show "DISCHARGING". This will not harm the

system and installation can continue.

BLUE WIRE

Specifications Subject to Change Without Notice

DWG 1

DWG 2

DIGITIZE, INC. 700256-0001 REV. C 01/06

SEBB-6/24 USER MANUAL

WIRE ARE 6FT. IN LENGTH