Cisco ASR 9922 매뉴얼 - 페이지 29

{카테고리_이름} Cisco ASR 9922에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASR 9922 44 페이지. Replacing cisco asr 9000 series router components

페이지 인쇄

Replacing Cisco ASR 9000 Series Router Components

rommon B1> RSP_LINK_1G=1

rommon B1> sync

Step 5

Verify that config register is set correctly in ROMMON:

Example:

rommon B1> confreg

Step 6

Reset RP2 card in ROMMON. Now the RP2 becomes the standby RP in slot 0 and synchronizes configuration

from active RSP440 in slot 1.

Example:

rommon B1> reset –h

Note

Step 7

Wait until standby node reach NSR-ready state and status of ALL the groups is Ready state. Use show

redundancy command to verify the same.

Step 8

From active RP, verify the both RPs have synchronized the SNMP engine ID and SNMP ifindex-table between

each other:

Example:

#more disk0:snmp/ifindex-table loc 0/rp0/cpu0

#more disk0:snmp/ifindex-table loc 0/rp1/cpu0

#more disk0:snmp/snmp_persist loc 0/rp0/cpu0

#more disk0:snmp/snmp_persist loc 0/rp1/cpu0

Step 9

Manually copy Embedded Event Manager (EEM) scripts from RP1 to RP2 disks if applicable.

Note

Step 10

Perform redundancy switchover from active RP1 to standby RP2.

Example:

Router# redundancy switchover

Note

Step 11

Verify that the active RP is RP2 and it has the running configuration from RP1.

Example:

Router# show redundancy summary

Router# show running config

Step 12

Remove RP1. Follow the procedure explained in the topic

on page

The RP2 card reloads and user is disconnected from ROMMON automatically.

The EEM scripts are files located on RP's hard disk. These files are not automatically synced

between Active and Standby RPs.

A physical OIR is not supported, hence you must perform CLI switchover.

25.

Removing and Replacing Cards from the Chassis,

Replacing Cisco ASR 9000 Series Router Components

Migrating from RP1 to RP2 Card