Argo RB14945 서비스 매뉴얼 - 페이지 8

{카테고리_이름} Argo RB14945에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Argo RB14945 12 페이지. Fuel system

Fuel System

15. Perform the servicing procedure, Inspecting the Fuel Tank

Installing the Fuel Tank (6x6 Vanguards prior to S7304)

Install any missing or torn pieces of cushioning to the fuel tank. There are 8 locations

that make contact with the fuel cage.

Assemble the cage and tank between the seat supports, at the same time reconnect-

ing the filler hose to the tank. As the fuel tank is completely installed, slide the fuel

neck intake assembly into the gas cap hole ensuring that the venting tube is vertical

to the vehicle body.

Tighten the gear clamp at the tank.

Reattach the fuel line to the pickup tube.

Fasten the fuel tank cage and seat to the seat support brackets. Tighten the bolts with

a socket and extension.

Insert the bolts squarely into the seat cushion and do not overtighten. Incorrectly

positioned and tightened bolts will strip or dislodge the thread inserts in the seat

cushions, resulting in a costly repair.

Reinstall the backrest.

Reinstall the front floor pan

Fuel Filter

All models of the ARGO are equipped with an in-line fuel filter (replacement fuel filter is

ARGO Part No. 125-64). On Conquest models the fuel filter is located in the fuel hose,

next to the fuel tank. On all other Argo models the fuel filter is located at the engine.

Replace the fuel filter after every 250 hours of operation or once a year. To replace the

filter, loosen the gear clamps with a standard screw driver and pull the rubber fuel lines

off of the filter. Install the new filter with the flow arrow pointing toward the engine.

Tighten the clamps securely. Start the engine and check for fuel leaks.

Ontario Drive & Gear Limited

PH.(519)- 662-2840 FAX (519)- 662-2421

Argo Service Manual

FS-8