Cisco C8510MSR-SKIT-DC - Catalyst 8510 Multiservice Switch Router 시작하기 - 페이지 7

{카테고리_이름} Cisco C8510MSR-SKIT-DC - Catalyst 8510 Multiservice Switch Router에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco C8510MSR-SKIT-DC - Catalyst 8510 Multiservice Switch Router 16 페이지. Getting started

페이지 인쇄
Figure 3: Closing the retaining latches on the front of a blade

Step two: Connect to Ethernet Port A

Connect an Ethernet cable from Ethernet Port A to an Ethernet switch (rather than a
hub, to minimize interference from other devices on the network). The Ethernet
port is a 10/100/1000 Mbps auto-sensing connection.
Ethernet Ports B, C and D may not be supported in the software supplied
i
with your blade. Do not connect to these ports unless the web interface
allows you to configure them. Do not connect multiple ports to the same
subnet unless instructed to do so by the web interface.
Installing the MCU MSE 8510
7