Argo S100 사용 설명서 - 페이지 6

{카테고리_이름} Argo S100에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Argo S100 8 페이지.

OPERATING INSTRUCTION:
1. adjust the Margin depth adjuster to set the desired Margin size as per the thickness
of the paper.
2. Set the Paper Stop Guide to the appropriate paper size setting by gently sliding it to
the left or right. Fasten the screw after get the right paper size (1.1).
3. Pull out the adjustable Push-pull Pins to meet the corresponding holes as per the pa-
per size
(1.2).
1.
4. Place papers flat on base of machine aligning it against the Paper Stop and sliding it
horizontally into the punching slot (2).
5. while holding the papers into place, slowly pull the Punching Handle down to punch
the papers (3).
3.
6. Push handle upward back into its initial position and remove the punched papers,
(4).
7. Select the appropriate size of the plastic
ring as per the papers thickness by Ring
Selection Guide (5) and put it onto
prongs of Binding Mechanism with opening
on top (see binding capacity chart).
Ring size (mm)
Sheet (70-80g)
8. Remove the Binding Handle to open the rings properly.
9. carefully insert punched papers onto the comb rings and then close the comb by re-
move the Binding Handle and finish binding (6), (7), (8).
6.
© aRGo S.a.
1
2
6
8
10 12,5 14
25
45
65 105 125 145 165 210 240 270 300 350 440 500
7.
2.
4.
5.
16
19
22
25 28,5 32
open
close
nasza oferta w internecie: www.argo.pl
38
45
51
8.