Cisco Catalyst 2960-XR 하드웨어 설치 매뉴얼 - 페이지 7
{카테고리_이름} Cisco Catalyst 2960-XR에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Catalyst 2960-XR 34 페이지.
Cisco Catalyst 2960-XR에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (25 페이지), 하드웨어 매뉴얼 (20 페이지)
페이지 인쇄
Switch Installation
• Make sure that you have access to the switch rear panel and to the rear of the rack.
Installing a FlexStack-Plus or a FlexStack-Extended Module
Note
The switch should always have a blank module installed when a FlexStack module is not used.
The Catalyst 2960X-48P-L switch is shown as an example. You can install the module in other switches as
shown.
Procedure
Step 1
Use a number 2 Phillips-head screwdriver to remove the FlexStack module blank cover on the switch back
panel.
Step 2
Grasp the FlexStack module on the sides, and insert it into the module slot. Push the module in completely
until you feel it snap into place.
The following example image uses FlexStack-Plus module.
OL-28309-02
◦ CAB-STK-E-3M= (3-meter cable)
Installing a FlexStack-Plus or a FlexStack-Extended Module
Catalyst 2960-X and 2960-XR Switch Hardware Installation Guide
7