Cisco Catalyst 3030 시작하기 매뉴얼 - 페이지 3
{카테고리_이름} Cisco Catalyst 3030에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Catalyst 3030 34 페이지. Cisco systems catalyst blade switch getting started guide
페이지 인쇄
Cisco Catalyst Blade Switch 3030 Getting Started Guide
Note
Cisco Gigabit Ethernet Switch Module Description
78-17052-01
Regulatory Compliance and Safety Information for the Cisco Catalyst Blade
•
Switch 3030
Registration card
•
Follow these steps:
Unpack and remove the switch module and the accessory kit from the
1.
shipping box.
Return the packing material to the shipping container, and save it for
2.
future use.
If the switch modules are ordered with the server chassis, the switch modules are
already installed, and no unpacking is required. The unpacking procedure applies
only if a switch module is ordered separately.
Figure 1
shows the switch module, which has these features:
•
10 internal Gigabit Ethernet 1000BASE-X ports
1 console port
•
2 external 10/100/1000BASE-T copper Gigabit Ethernet ports
•
4 external small form-factor pluggable (SFP) module uplink ports that
•
support 1000BASE-SX fiber and 10/100/1000BASE-T copper (only Cisco
SFP modules are supported)
Each port has an LED associated with it. Additionally, there is a System
Status/ID LED that is controlled by the Dell Remote Access Controller/Modular
Chassis (DRAC/MC) management board.
Cisco Catalyst Blade Switch 3030 Getting Started Guide
Taking Out What You Need
1-3