Cisco Catalyst 5500 매뉴얼 - 페이지 12
{카테고리_이름} Cisco Catalyst 5500에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Catalyst 5500 19 페이지. Multiswitch router
페이지 인쇄
Replacing Hardware Components
Turn the power switch to the OFF (0) position on the power supply you are removing (see
Step 2
Remove the two screws securing the terminal block cover and slide the cover straight off the terminal
Step 3
block (see
Figure 7-9
Terminal
block
cover
Remove
Power
switch
Disconnect the DC-input wires from the terminal block. Disconnect the ground wire last.
Step 4
Disconnect the central office (CO) ground from the CO ground connector
Step 5
Figure 7-10 DC-Input Power Supply CO Ground
CO ground
connector
location
Loosen and remove the captive screws on the power supply (see
Step 6
Use both hands to remove and install power supplies.
Caution
Grasp the power supply handle with one hand and place your other hand underneath as you slowly pull
Step 7
the power supply out of the bay (see
Cisco MGC Software Release 7 Operations, Maintenance, and Troubleshooting Guide
7-12
Figure
7-9).
DC-Input Power Supply Front Panels
Remove
DC
FAN OUTPUT
OK
OK
FAIL
Captive screw
o
Chapter 7
Maintaining the Cisco Catalyst 5500 Multiswitch Router
o
Figure
7-11).
Figure
(Figure
7-10).
Figure
7-9).
7-9).
OL-0542-06