Cisco Catalyst 7500 Series 매뉴얼 교체 - 페이지 28

{카테고리_이름} Cisco Catalyst 7500 Series에 대한 매뉴얼 교체을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Catalyst 7500 Series 40 페이지. Chassis interface board
Cisco Catalyst 7500 Series에 대해서도 마찬가지입니다: 데이터시트 (11 페이지), 문제 해결 매뉴얼 (11 페이지), 구성 매뉴얼 (50 페이지)

페이지 인쇄
Cisco Catalyst 7500 Series 매뉴얼 교체
Replacing the CI in the Cisco 7513
Step 4
Step 5
This completes the CI removal procedure.
Figure 19
Replacing the CI
When you replace the CI, hold it in the orientation shown in Figure 19. Position the board over the
backplane connector and align the four standoff holes in the corners of the board with the four
standoffs.
Follow these steps to replace the CI:
Step 1
Caution
panel and two are above it. To avoid damaging CI components when you remove the CI, do not hit
the CI against the chassis panel.
28 Replacing the Chassis Interface (CI) Board in the Cisco 7500 Series Chassis
Grasp the edges of the CI (as shown in Figure 19) and pull it away from the backplane, up
and out from behind the chassis panel. If necessary, gently rock the CI from side to side
very slightly to dislodge its connector pins from the backplane connector.
Place the CI in an antistatic bag.
Removing and Replacing the CI—Cutaway View
Attach an ESD-preventive strap between you and an unpainted chassis surface.
Access to the CI is partially blocked by a chassis panel. Two of the screws are below this
Chassis interface
standoffs (4)