Cisco Catalyst 8300 Series 하드웨어 설치 매뉴얼 - 페이지 13

{카테고리_이름} Cisco Catalyst 8300 Series에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Catalyst 8300 Series 46 페이지. Edge ucpe

Prepare for Installation

•

Review the safety warnings listed in Regulatory Compliance and Safety Information for the Cisco Catalyst

8300 Series Edge uCPE before installing, configuring, or maintaining the device.

Read the following safety guidelines before you install this product:

Warning

Always follow these electrostatic discharge (ESD) prevention procedures when removing and replacing

modules:

• Ensure that the chassis is electrically connected toground.

Safety Recommendations and Warnings, on page 9

Safety with Electricity, on page 10

Site Requirements, on page 11

Mounting Requirements, on page 11

Power Guidelines and Requirements, on page 12

Network Cabling Specification, on page 12

Required Tools and Equipment, on page 13

This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work

on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard

practices for preventing accidents. Use the statement number provided at the end of each warning to locate

its translation in the translated safety warnings that accompanied this device. Statement 1071

Ultimate disposal of this product should be handled according to all national laws and regulations. Statement

9001

Installation of the equipment must comply with local and national electrical codes. Statement 1074

C H A P T E R

Cisco Catalyst 8300 Series Edge uCPE Hardware Installation Guide