Digitone DCB Plus 소유자 매뉴얼 - 페이지 5

{카테고리_이름} Digitone DCB Plus에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digitone DCB Plus 16 페이지. Automatically blocks and routes screened calls with caller id

Inviting VIP Callers
- Numbers
Inviting VIP Callers can be entered by First using the Call History Up or Down viewing buttons to put
the dashes in the selected number, then press the Invite button Twice quickly on the front panel.
"NBR VIP" will display and the red LED indicator will flash to show that call is now on the VIP Call List.
When a VIP caller calls in, the caller ID will display their number and "VIP".
Clearing Display – Just One Number
To delete a single number from Call History, use the Call History Up or Down arrow keys to select the
number you want to remove. Notice the number has dashes between the digits, Ex. 602-555-1234, Press
and hold the Block Button for 3 seconds, then see "Release Button" displayed. Release the button to
clear that displayed call.
Clearing Display – All Displayed Numbers
To Remove the entire Call History, if a number has dashes between the digits, wait until the dashes
are removed, Ex. 6025551234 and only the number shows, then Press and hold the Block Button for 3
seconds, you will then see "Release Button". "CID List Deleted" will then display, clearing all call history.

Reviewing Call History

The left Up arrow button displays the previous calls or Top of List. The
right button Down arrow button displays the last call or End of List. When Call History starts to fill up
with calls, you can jump to the Top of List or the End of List by pressing and holding the Up arrow key
to go to the Top of List or pressing and holding the Down arrow key to go to the End of List.

Advanced User Settings

Programming Features

How do I enter into Programming?
The DCB Plus must be connected properly to an analog telephone line source in the LINE port, with an
analog telephone connected to the TEL port. The DCB Plus will display "Line in Wrong Port" until
telephone service is connected to the LINE port. Power must be connected to the DCB Plus with the
Digitone supplied 24VDC power adapter. You will not be able to program the DCB Plus unless the above
conditions are met. Leave all other phone devices you have connected to their own power supplies.
With this setup done, press and hold the Program Button for 3 seconds until you see the red LED light,
then release button, see "Program Mode", then "Pick Up Phone". Note that if you are using a cordless
phone handset you will also have to press the Talk button. When you pick up that phone connected
to the TEL phone port on the back of the DCB Plus, the display will now show "Enter Code". You must
remain on the line using your phone offhook when programming, so don't hang-up the phone. Enter any
4