Cisco Content Engine 565 설치 매뉴얼 - 페이지 17

{카테고리_이름} Cisco Content Engine 565에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Content Engine 565 28 페이지. Content engine

Insert the tab (labeled 1 in

Step 4

the two clip nuts or cage nuts on the rear flange.

Figure 9

Tab

Rear flange

Align the slide rail assembly to the front flange on the rack and insert and tighten two M6 screws to

Step 5

secure the slide rail to the front flange. (See

Note

Repeat

Align and insert the inner slide rails into the slide rail assemblies until they lock into place.

Step 6

Slide the Content Engine into the rack until the Content Engine locks into place.

Step 7

78-14731-02

Figure

9) on the rear of the slide rail assembly through the center hole between

Attaching the Slide Rails to the Rack

Rear

If it is necessary to adjust the length of the slide rail, loosen the adjustment screw (labeled 2 in

Figure

9) in on the rear of the slide rail and then adjust the length of the slide rail and tighten the

adjustment screw.

Step 4

and

Step 5

to install the other slide rail assembly.

Installing a Content Engine 510 or 565 Unit

Front

Adjustment screw

Figure

9.)

Installing the Cisco Content Engine 510 and 565