Argo-Hytos LubMon Connect 빠른 시작 매뉴얼 - 페이지 3

{카테고리_이름} Argo-Hytos LubMon Connect에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Argo-Hytos LubMon Connect 7 페이지.

B) Connecting LubMon Connect to the Internet

2. Connect LubMon Connect to the power supply and then correctly connect your power

supply to line voltage.

3. Now establish a connection between LubMon Connect and the Internet. You can find

detailed information about this in the manual.

C) Sensor connection

4. Make sure that the CAN interface is activated for all the sensors used, that the baud rate is

set to the same known value and that the node IDs of the sensors are all different and

known (the sensor configuration is explained in the respective manuals).

5. Connect the CAN sensor cable to the sensor with the M12x8 connector.

6. Connect the 9-pin CAN-Sub-D cable connector to the corresponding LubMon Connect

interface.

7. Now connect the sensors and the LubMon Connect, if necessary using additional T-pieces

and extension cables (cf.: Manual LubMon Connect).

D) Gateway configuration

8. Connect your computer to the same network as the gateway and start the tool

"Ethernet_Config.exe". Configure the network settings of the gateway according to your

requirements (cf.: Manual LubMon Connect).

9. The tool "RI_Config.exe" can then be used to enter the node ID and the CAN baud rate of

the sensors. (cf.: Manual LubMon Connect).