Argo-Hytos TSE3-D 사용 설명서 - 페이지 11
{카테고리_이름} Argo-Hytos TSE3-D에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Argo-Hytos TSE3-D 12 페이지. Electronic pressure switch
페이지 인쇄Display colour change with parameters
[r-cF], independent of OUT1.
Measured value between cFL and cFH;
Display = red
10 Operation
After power on, the unit is in the Run mode (= normal operating mode). It carries out its measurement and evaluation functions and provides output
signals according to the set parameters.
Operation indication → 7 Operating and display elements.
10.1 Read set parameters
► Press [●].
► Press [▲] or [▼] until the requested parameter is displayed.
► Briefly press [●].
> The unit displays the corresponding parameter value for approx. 30 s; then it changes to the process value display.
10.2 Self-diagnosis / error indications
The unit has many self-diagnostic options.
› It monitors itself automatically during operation.
› Warnings and faults are displayed (even if the display is deactivated), in addition they are available via the parameter setting software.
none
SC
flashes
flashes
flashes
SC1
flashes
flashes
SC2
flashes
flashes
Loc
C.Loc
S.Loc
OL
UL
Err flashes
*) F = fault
W = warning
**) The output remains deactivated as long as the excessive current / short circuit continues.
Page 11
Display colour change with parameter
[G-cF], independent of OUT1.
Measured value between cFL and cFH;
Display = green
Fault / warning
F
Supply voltage too low.
Excessive current at switching
F
outputs OUT1 and OUT2 **).
F
Excessive current at switching outputOUT1 **).
F
Excessive current at switching output OUT2 **).
W
Parameter setting locked via pushbuttons
Parameter setting locked via pushbuttons,
W
parameter setting is active via IO-Link
communication → 9.1.
Setting buttons locked via parameter software.
W
Parameter change is rejected → 9.1.
Process value too high
W
(measuring range exceeded).
Process value too low
W
(value below measuring range).
F
Internal fault / malfunction.
Colour change display green
Colour change display red
1
Initial value of the measuring range
2
Final value of the measuring range
Lower limit value (independent of
cFL
the output function)
Upper limit value (independent of
cFH
the output function)
Corrective measures
► Check / correct the supply voltage.
► Check switching outputs for short-circuit or
excessive current; remove the fault.
► Check switching output OUT1 for
short-circuit or excessive current; remove the fault.
► Check switching output OUT2
for short-circuit or excessive current;
remove the fault.
► Unlock buttons → 9.1 Parameter setting
in general →"Locking / unlocking".
► Wait until parameter setting via IO-Link
is finished.
► Unlocking only possible via
IO-Link interface / parameter setting software.
► Check / reduce system pressure / select unit
with corresponding measuring range.
► Check / increase system pressure / select unit
with corresponding measuring range.
► Contact the manufacturer.
More information at www.argo-hytos.com
Subject to change · TSE3-D_9193_1en_09/2019