Cisco CWDM-GBIC-1570 설치 참고 사항 - 페이지 22

{카테고리_이름} Cisco CWDM-GBIC-1570에 대한 설치 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco CWDM-GBIC-1570 36 페이지. Passive optical system
Cisco CWDM-GBIC-1570에 대해서도 마찬가지입니다: 설치 및 사양 매뉴얼 (24 페이지)

페이지 인쇄

Connecting the CWDM Passive Optical System to Your System

Before removing the dust plugs and making any optical connections, observe the following guidelines:

Note

Always keep the protective dust plugs on the unplugged fiber-optic cable connectors and the

•

transceiver optical bores until you are ready to make a connection.

Always inspect and clean the SC connector end-faces just before making any connections. Refer to

•

the Tip on this page for a pointer to a fiber-optic inspection and cleaning white paper.

Always grasp the SC connector housing to plug or unplug a fiber-optic cable.

•

Remove the dust plugs from the network interface cable connector and the transceiver optical bore. Save

Step 2

the dust plugs for future use.

Inspect and clean the connecor's fiber-optic end-faces. Refer to the Tip below for a pointer to the

Step 3

fiber-optic inspection and cleaning white paper.

For complete information on inspecting and cleaning fiber-optic connections, refer to the whitepaper at

Tip

this URL:

http://www.cisco.com/en/US/tech/tk482/tk607/technologies_white_paper09186a0080254eba.shtml

Connect the single-mode fiber-optic cables from the CWDM GBICs (Tx/Rx; up to four channels) to the

Step 4

4-channel module equipment connectors (Tx/Rx; up to four wavelengths, 1470-nm, 1490-nm, 1510-nm,

1530-nm) for OADM4-1 or 1550-nm, 1570-nm, 1590-nm, and 1610-nm for OADM4-2.

Note

Connect the one backbone single-mode fiber-optic cable to the NETWORK connector on the OADM

Step 5

module, and connect the other backbone single-mode fiber-optic cable to the PASS connector on the

OADM module.

If you are planning to monitor your network with an optical power meter or an optical spectrum analyzer,

Step 6

connect your meter or analyzer to the MONITOR port on the OADM.

Cisco CWDM Passive Optical System Installation Note

Connect the Tx ports to the Rx ports and the Rx ports to the Tx ports to ensure that the system

operates correctly.

78-16565-02