Cisco CWDM-GBIC-1590 설치 및 사양 매뉴얼 - 페이지 18

{카테고리_이름} Cisco CWDM-GBIC-1590에 대한 설치 및 사양 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco CWDM-GBIC-1590 24 페이지. Passive optical system
Cisco CWDM-GBIC-1590에 대해서도 마찬가지입니다: 설치 참고 사항 (36 페이지)

페이지 인쇄

Installing an SFP Module

Note

Figure 8

Step 4

Carefully slide the GBIC module into the GBIC slot and seat it. When installed, the GBIC module

input/output panel should be flush with the face of the interface panel.

Step 5

Attach the network interface fiber-optic cable, as described in the

Module Interface Cables" section on page

save the plug for future use.

This completes the procedure for installing a GBIC module.

Installing an SFP Module

SFP modules ordered with the system come installed in the system. Optical fiber cables are

commercially available; they are not available from Cisco.

Gigabit Interface Converter (GBIC) Module and Small Form-Factor Pluggable (SFP) GBIC Module Installation Information and Specifications

Some horizontally oriented devices accept the GBIC module with the alignment groove on top.

Other devices accept the GBIC module with the alignment groove on the bottom. (See

If the GBIC module does not go into the interface slot, ensure that the alignment groove and the

interface opening are lined up and, if necessary, flip the GBIC module over (rotate it 180

degrees) and try inserting it again.

Inserting a GBIC Module with Alignment Groove on the Bottom

Alignment groove

"Installing the GBIC Module or SFP

20, remove the plug from the GBIC module optical bores, and

Figure

8.)

OL-5067-08