Cisco CWDM-GBIC-1610 설치 및 사양 매뉴얼 - 페이지 16

{카테고리_이름} Cisco CWDM-GBIC-1610에 대한 설치 및 사양 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco CWDM-GBIC-1610 24 페이지. Passive optical system
Cisco CWDM-GBIC-1610에 대해서도 마찬가지입니다: 설치 참고 사항 (36 페이지)

페이지 인쇄

Installing and Removing the GBIC Module or SFP Module

You can determine whether your equipment is causing interference by turning it off. If the interference

stops, it was probably caused by the Cisco equipment or one of its peripheral devices. If the equipment

causes interference to radio or television reception, try to correct the interference by using one or more

of the following measures:

•

This product has been designed to meet these requirements. Modifications to this product that are not

Note

authorized by Cisco , could void the various approvals and negate your authority to operate the product.

Installing and Removing the GBIC Module or SFP Module

GBIC modules or SFP modules might ship already installed in your device, or they might arrive

packaged separately. This section describes how to install or remove the GBIC module or SFP module

from your Gigabit Ethernet interface.

You can install and remove GBIC modules or SFP modules with power on to the system; however, we

Note

strongly recommend that you do not install or remove the GBIC module or SFP module with optical fiber

cables attached to it. Disconnect all cables before removing or installing a GBIC module or SFP module.

To prevent system problems, do not use GBIC modules or SFP modules from third-party vendors. Use

Caution

only GBIC modules or SFP modules supplied by Cisco.

Removing a GBIC Module or SFP Module

Ultimate disposal of this product should be handled according to all national laws and regulations.

Warning

You can install and remove GBIC modules or SFP modules with power on to the system; however, we

Note

strongly recommend that you do not install or remove the GBIC module or SFP module with optical fiber

cables attached to it. Disconnect all cables before removing or installing a GBIC module or SFP module.

To remove a GBIC module, perform the following steps:

Disconnect the network fiber cable from the GBIC module SC-type connector or SFP module LC-type

Step 1

connector.

Gigabit Interface Converter (GBIC) Module and Small Form-Factor Pluggable (SFP) GBIC Module Installation Information and Specifications

Turn the television or radio antenna until the interference stops.

Move the equipment to one side or the other of the television or radio.

Move the equipment farther away from the television or radio.

Plug the equipment into an outlet that is on a different circuit from the television or radio. (That is,

make certain the equipment and the television or radio are on circuits controlled by different circuit

breakers or fuses.)

OL-5067-08