Cisco CWDM-GBIC-1610 설치 참고 사항 - 페이지 24
{카테고리_이름} Cisco CWDM-GBIC-1610에 대한 설치 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco CWDM-GBIC-1610 36 페이지. Passive optical system
Cisco CWDM-GBIC-1610에 대해서도 마찬가지입니다: 설치 및 사양 매뉴얼 (24 페이지)
페이지 인쇄
Connecting the CWDM Passive Optical System to Your System
Figure 19
SC connector
To network
Note
Before removing the dust plugs and making any optical connections, observe the following guidelines:
Always keep the protective dust plugs on the unplugged fiber-optic cable connectors and the
•
transceiver optical bores until you are ready to make a connection.
•
Always inspect and clean the SC connector end-faces just before making any connections. Refer to
the Tip on this page for a pointer to a fiber-optic inspection and cleaning white paper.
•
Always grasp the SC connector housing to plug or unplug a fiber-optic cable.
Remove the dust plugs from the network interface cable connector and the transceiver optical bore. Save
Step 2
the dust plugs for future use.
Inspect and clean the connecor's fiber-optic end-faces. Refer to the Tip below for a pointer to the
Step 3
fiber-optic inspection and cleaning white paper.
For complete information on inspecting and cleaning fiber-optic connections, refer to the white-paper
Tip
document at this URL:
http://www.cisco.com/en/US/tech/tk482/tk607/technologies_white_paper09186a0080254eba.shtml
Cisco CWDM Passive Optical System Installation Note
24
Cabling a CWDM 8-Channel Multiplexer/Demultiplexer Module
CWDM
GBIC
SC connector
CAB-SM-LCSC-1M
TX
NE TW OR
K
CW DM
-
RX
MU X-8
TX
147 0
A
RX
TX
151 0
TX
MO NIT OR
RX
RX
TX
155 0
TX
149 0
RX
TX
159 0
RX
TX
153 0
RX
RX
TX
157 0
RX
TX
161 0
RX
LC connectors
To second
network
CWDM
GBIC
LC connector
TX
NE TW OR
K
CW DM
-
RX
MU X-8
TX
147 0
A
RX
TX
151 0
TX
MO NIT OR
RX
RX
TX
TX
149 0
RX
TX
153 0
RX
TX
To optional
spectrum analyzer
Module
CWDM
SFP
155 0
RX
TX
159 0
RX
157 0
RX
TX
161 0
RX
78-16565-02