Cisco Firepower 4100 Series 제품 설명서 - 페이지 10

{카테고리_이름} Cisco Firepower 4100 Series에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Firepower 4100 Series 17 페이지. Rack-mount and ground the chassis
Cisco Firepower 4100 Series에 대해서도 마찬가지입니다: 매뉴얼 (8 페이지), 유지 관리 및 업그레이드 매뉴얼 (20 페이지), 매뉴얼 (36 페이지), 매뉴얼 (8 페이지), 매뉴얼 (42 페이지), 매뉴얼 (38 페이지)

Cisco Firepower 4100 Series 제품 설명서
Performing Power On Self Test
Perform these steps to complete POST and Operating System software initialization:
This procedure is written assuming that you have connected the CLI console to the controller as
Note
described in
Plug an AC power cord into the rear of the controller, and connect the other end to a grounded 100 to
Step 1
240 VAC 50/60 Hz electrical outlet.
Cisco supplies country specific standard power cord if you order it with the controller; be sure the
Note
controller end of the cord conforms with the IEC 320 standard.
If you wish to run a previous version of the controller code, press the <ESC> key immediately after the
Note
Model and S/N line. This will take you to the Bootloader Boot Options Menu.
Step 2
Monitor the controller bootup using the CLI screen:
The Bootup script displays Operating System software initialization (code download and POST
verification) and basic configuration as shown in the following sample bootup display:
.o88b. d888888b .d8888.
d8P
8P
8b
Y8b
`Y88P' Y888888P `8888Y'
Press <ESC> now for additional boot options...
(If desired, press <ESC> now to display the Bootloader Boot Options Menu.)
Please choose an option from below:
1.
2.
3.
4.
Please enter your choice:
(Enter 1 to run the current Code, enter 2 to run the previous Code, enter 4 to run the current Code and
clear the controller configuration to factory defaults. Do not enter 3 unless directed to do so by Cisco
Technical Assistance Center (TAC).)
BOOT Uncompressing RTOS Image ... OK
Loading Code at f0100000 ...
Relocating Code to 0785e000, end 07fa649e ... OK
Detecting hardware . . . .
(This may take a long time. Do not reboot the controller at this time.)
(The rest of this process takes two to three minutes. Do not reboot the controller until you receive the
user login prompt.)
Software Copyright 2004 <company name> All rights reserved.
Cisco 4100 Series Wireless LAN Controllers - Installation and Configuration Guide
10
"Connecting and Using the CLI
.o88b.
Y8
`88'
88'
YP d8P
88
`8bo.
8P
88
`Y8b. 8b
d8
.88.
db
8D Y8b
Boot Options
Run active image (version 3.0.80.0)
Run backup image (version 3.0.57.0)
Manually perform system upgrade
Clear Configuration
Console."
.d88b.
Y8 .8P
Y8.
88
88
88
88
d8 `8b
d8'
`Y88P'
`Y88P'
Model
Installation and Configuration
S/N: 01012403-10037905-01007
78-17155-01