Cisco Firepower 4110 매뉴얼 - 페이지 26

{카테고리_이름} Cisco Firepower 4110에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Firepower 4110 26 페이지. Rack-mount and ground the chassis
Cisco Firepower 4110에 대해서도 마찬가지입니다: 유지 관리 및 업그레이드 매뉴얼 (20 페이지), 매뉴얼 (36 페이지), 매뉴얼 (8 페이지), 매뉴얼 (42 페이지), 시작하기 (42 페이지)

페이지 인쇄

Install the FIPS Opacity Shield

Figure 18: Attach the FIPS Opacity Shield to the Cable Management Brackets

FIPS opacity shield

Cable management bracket

Step 8

Attach the 15 TELs. For information on the procedure and correct placement of the TELs, see the Tamper Evidence

Label (TEL) Placement section (section 2.13 ) in the

document.

Step 9

Attach the power cable to the chassis and connect it to an electrical outlet.

Step 10

Press the power switch on the rear panel.

Step 11

Check the power LED on the front panel. See

indicates that the chassis is powered on.

Note

When you toggle the power switch from ON to OFF, it takes several seconds for the system to power down.

Do not remove the power cable until the power LED is off. After removing power from the chassis either by

moving the power switch to OFF or unplugging the power cord, wait at least 10 seconds before turning power

back ON.

Step 12

See the

Cisco Firepower 4100 Getting Started Guide

Installation, Maintenance, and Upgrade

8-32 x 0.375-inch Phillips screws (two per side)

FIPS 140-2 Non Proprietary Security Policy Level 2 Validation

Front Panel LEDs

for a description of the power LED. Solid green

for further configuration information.

Installation, Maintenance, and Upgrade