Cisco Firepower 4150 유지 관리 및 업그레이드 매뉴얼 - 페이지 5

{카테고리_이름} Cisco Firepower 4150에 대한 유지 관리 및 업그레이드 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Firepower 4150 20 페이지. Rack-mount and ground the chassis
Cisco Firepower 4150에 대해서도 마찬가지입니다: 매뉴얼 (36 페이지), 매뉴얼 (26 페이지), 매뉴얼 (8 페이지), 매뉴얼 (42 페이지), 시작하기 (42 페이지)

페이지 인쇄

1. Remove and Replace the Ssd

Maintenance and Upgrade

Note

The system supports operation with a single fan failure (N+1 fan redundancy), but do not run the system for

an extended amount of time without all fan modules installed. Keep removal and replacement time at three

minutes. Remove and replace one fan module at a time.

Step 1

To remove a fan module, face the rear of the chassis, and grasp the handle of the fan module.

Step 2

Squeeze the handle to disengage the latches on the left and right of the fan module.

Step 3

Pull the fan module out of the chassis.

Figure 2: Remove the Fan Module

Step 4

To replace a fan module, hold the fan module in front of the fan slot.

Step 5

Push the fan module into the chassis until it is properly seated and the latches snap into place.

If the system is powered on, listen for the fans. You should immediately hear the fans operating. If you do not hear the

fans, make sure the fan module is inserted completely into the chassis and the faceplate is flush with the outside surface

of the chassis.

Step 6

Verify that the fan is operational by checking the fan module LED. See

LEDs.

Remove and Replace the SSD

Take note of the following warnings:

Remove and Replace the SSD

Front Panel LEDs

for a description of the fan

Maintenance and Upgrade