Cisco Firepower 4150 매뉴얼 - 페이지 16

{카테고리_이름} Cisco Firepower 4150에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Firepower 4150 26 페이지. Rack-mount and ground the chassis
Cisco Firepower 4150에 대해서도 마찬가지입니다: 유지 관리 및 업그레이드 매뉴얼 (20 페이지), 매뉴얼 (36 페이지), 매뉴얼 (8 페이지), 매뉴얼 (42 페이지), 시작하기 (42 페이지)

페이지 인쇄

Connect the DC Power Supply Module

Warning

Step 1

Install the DC power supply module in the chassis and make note of the bay number so you can connect the wiring to

the correct terminals on the DC power supply module at the rear of the chassis. See

Supply Module, on page 9

Step 2

Verify that the power is off to the DC circuit on the power supply module that you are installing.

Step 3

Make sure that all site power and grounding requirements have been met.

Step 4

To remove the plastic cover from the terminal block, insert a flat screw driver on the side of the plastic cover and pry

it off.

Figure 6: Remove the Plastic Cover

Step 5

To prevent any contact with metal lead on the ground wire and the plastic cover, you must wrap the positive and negative

lead cables with sleeving. Insulate the lug with shrink sleeving for each lead wire if using noninsulated crimp terminals.

Sleeving is not required for insulated terminals.

Step 6

Remove the two M5 screws.

Installation, Maintenance, and Upgrade

Statement 1090 Installation by Skilled Person

Only a skilled person should be allowed to install, replace, or service this equipment. See statement 1089

for the definition of a skilled person.

Statement 1091 Installation by an Instructed Person

Only an instructed person or skilled person should be allowed to install, replace, or service this equipment.

See statement 1089 for the definition of an instructed or skilled person.

for the procedure.

Installation, Maintenance, and Upgrade

Remove and Replace the Power