Cisco FPR1150-ASA-K9 하드웨어 설치 매뉴얼 - 페이지 37

{카테고리_이름} Cisco FPR1150-ASA-K9에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco FPR1150-ASA-K9 42 페이지.

Installation, Maintenance, and Upgrade

•

The Firepower 1100 ships with an SSD installed. You can replace this SSD should it fail. Before replacing

the SSD, you must power off the chassis by pressing the power switch on the rear panel.

Caution

Follow these steps to replace an SSD in the chassis:

Step 1

Loosen the thumb screws on both sides of the SSD bay and pull the existing SSD out of the bay.

Step 2

Insert the new SSD into the bay and push it in until it is seated.

Replace the SSD, on page 33

Install the FIPS Opacity Shield in a Two-Post Rack, on page 34

You will lose your configuration after you replace the existing SSD with a new SSD.

C H A P T E R

Cisco Firepower 1100 Series Hardware Installation Guide